1. Right turn
2. Left turn
3. Move and hold the lever partway to signal a lane change.
The right hand signal will flash until you release the lever.
4. Move and hold the lever partway to signal a lane change.
The left hand signal will flash until you release the lever.
- Turn signals can be operated when
►Vehicles with smart key system The “ENGINE START STOP” switch is in IGNITION ON mode.
►Vehicles without smart key system The engine switch is in the “ON” position.
- If the indicators flash faster than usual
Check that a light bulb in the front or rear turn signal lights has not burned out.
Precaution
PRECAUTION
1. NOTICE FOR INITIALIZATION:
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize
the following systems after the cable is reconnected.
System Name
See Procedure
Back D ...
Personal/interior lights
► Front
On/off
The illuminated entry system is activated even if the light is turned off when
the personal/interior light main switch is in door position.
► Rear
On/off
The illuminated entry system is activated even if the light is turne ...
High Mounted Stop Light Assembly
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE CENTER STOP LIGHT ASSEMBLY
(a) Using a short screwdriver, remove the 2 screws.
(b) Disconnect the connector and remov ...