Toyota Venza: TS and CG Terminal Circuit

Toyota Venza Service Manual / Brake Control / Dynamic Control Systems / Vehicle Stability Control System / TS and CG Terminal Circuit

DESCRIPTION

In the Test Mode (signal check), a malfunction in the speed sensor that cannot be detected when the vehicle is stopped can be detected while driving.

Transition to the sensor check mode can be performed by connecting terminals TS and CG of the DLC3 and turning the ignition switch from off to ON.

WIRING DIAGRAM

PROCEDURE

1.	CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - TS of DLC3)

(a) Disconnect the skid control ECU connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
A42-16 (TS) - D1-12 (TS)	Always	Below 1 Ω
D1-12 (TS) - Body ground	Always	10 kΩ or higher

Text in Illustration

Front view of wire harness connector

(to Brake Actuator (Skid Control ECU))

Front view of DLC3

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.	CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
D1-4 (CG) - Body ground	Always	Below 1 Ω

Text in Illustration

*1	Front view of DLC3

HINT:

If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (See page ).

REPLACE BRAKE ACTUATOR ASSEMBLY

REPAIR OR REPLACE HARNESS OR CONNECTOR

TC and CG Terminal Circuit

DESCRIPTION Connecting terminals TC and CG of the DLC3 causes the ECU to display the DTC by blinking the ABS warning and slip indicator lights. WIRING DIAGRAM CAUTION / NOTICE / HINT HINT: Wh ...

Vsc Off Switch

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized ...

Other materials about Toyota Venza:

Utility vehicle feature
• Specific design characteristics give it a higher center of gravity than ordinary passenger cars. This vehicle design feature causes this type of vehicle to be more likely to rollover. And, utility vehicles have a significantly higher rollover rate th ...

Installation
INSTALLATION PROCEDURE 1. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY NOTICE: Do not replace the spiral cable with the battery connected and the ignition switch on (IG). Do not rotate the spiral cable with the battery connected and the ig ...

Door Courtesy Switch Circuit
DESCRIPTION The main body ECU (driver side junction block assembly) detects the condition of the door courtesy light switch. WIRING DIAGRAM PROCEDURE 1. READ VALUE USING TECHSTREAM (a) Connect the Techstream to the DLC3 ...