Toyota Venza: Trip information
Display items can be switched by pressing the “INFO-CLOCK” button.
- Average fuel consumption (AVERAGE ECON)
Displays the average fuel consumption since the function was reset.
• The function can be reset by pressing and holding the “RESET-H” button when the average fuel consumption is displayed.
• Use the displayed average fuel consumption as a reference.
- Current fuel consumption (CURRENT ECON)
Displays the current rate of fuel consumption.
- Driving range (RANGE)
Displays the estimated maximum distance that can be driven with the quantity of fuel remaining.
• This distance is computed based on your average fuel consumption. As a result, the actual distance that can be driven may differ from that displayed.
• When only a small amount of fuel is added to the tank, the display may not be updated.
When refueling, turn the “ENGINE START STOP” switch off. If the vehicle is refueled without turning the “ENGINE START STOP” switch off, the display may not be updated.
- Average vehicle speed (AVERAGE SPEED)
Displays the average vehicle speed since the function was reset.
The function can be reset by pressing and holding the “RESET-H” button when the average vehicle speed is displayed.
Switching the display
1. “INFO-CLOCK” button
2. “RESET-H” button
To reset the functions below, press the “RESET-H” button.
• Average fuel consumption
• Average vehicle speed
3. “US/M-M” button ...
Setting the clock
Press and hold the “INFO-CLOCK”
button until part of the display begins to flash.
Press and hold the “RESET-H” button
to adjust the hours and the “US/M-M” button to adjust the minut ...
Other materials about Toyota Venza:
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE NO. 2 HEADLIGHT BULB (for Halogen Headlight)
(a) Turn the No. 2 headlight bulb in the direction indicated by the arrow
shown in the illustration, and remove it.
NOTICE:
Do not touch the bulb glass.
...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE NO. 1 AIR DUCT SUB-ASSEMBLY
(a) Disengage the 4 claws and remove the No. 1 air duct sub-assembly.
2. REMOVE AIR FILTER COVER PLATE
(a) Disengage the 2 cla ...
Brake Signal Malfunction (B2284)
DESCRIPTION
The power management control ECU receives brake signal information from 2 sources.
It receives a signal from the stop light switch assembly via a direct line, and
a signal from the ECM via CAN. If the information from these 2 sources is incons ...
0.1542