Display items can be switched by pressing the “INFO” button.
- Average Fuel Economy
Displays the average fuel consumption since the function was reset.
• The function can be reset by pressing and holding the “SELECT RESET” button when the average fuel economy is displayed.
• Use the displayed average fuel consumption as a reference.
- Current Fuel Economy
Displays the current rate of fuel consumption.
- Distance to Empty
Displays the estimated maximum distance that can be driven with the quantity of fuel remaining.
• This distance is computed based on your average fuel consumption. As a result, the actual distance that can be driven may differ from that displayed.
• When only a small amount of fuel is added to the tank, the display may not be updated. When refueling, turn the “ENGINE START STOP” switch off. If the vehicle is refueled without turning the “ENGINE START STOP” switch off, the display may not be update.
- Average Speed
Displays the average vehicle speed since the function was reset.
The function can be reset by pressing and holding the “SELECT RESET” button when the average speed is displayed.
- Trip Timer
Displays the elapsed time since the timer was reset.
The timer only functions when the engine is running. The timer can be started and paused by pressing the “SELECT RESET” button, and reset by pressing and holding the “SELECT RESET” button when the trip timer is displayed.
The display layout may be customized to show 1 line of trip information in the normal font size, 2 lines in the normal font size, or 1 line in a larger font size. When 2 lines of trip information are displayed, it is possible for both of them to be reset.
Press the “SELECT RESET” button.
The first display item that may be reset will be highlighted yellow.
Press the “SELECT RESET” button to
select or reset each display item as described above.
Press the “SETUP” button to change
which display items to reset by highlighting it in yellow.
This function only applies if both lines can be adjusted.
Press the “INFO” button to exit the
adjusting mode.
Press the “INFO” button a second time to switch the display items.
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page ).
2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
3. REMOVE CO ...
Removal
REMOVAL
CAUTION / NOTICE / HINT
NOTICE:
Do not replace the spiral cable with the battery connected and the ignition
switch ON.
Do not rotate the spiral cable without the steering wheel with the battery
connected and the ignition switch O ...
Installation
INSTALLATION
PROCEDURE
1. ADJUST COMPRESSOR OIL LEVEL
(a) When replacing the cooler compressor assembly with a new one, gradually
discharge the inert gas (helium) from the service valve, and drain the following
amount of oil from the vent ...