Toyota Venza: Transmitter ID not Registered (C2171/71)

Toyota Venza Service Manual / Tire Pressure Monitoring / Tire Pressure Warning System / Transmitter ID not Registered (C2171/71)

DESCRIPTION

Each tire pressure warning valve and transmitter ID is registered to the tire pressure warning ECU.

When the ECU detects a transmitter ID code not registered in the ECU, a DTC is output.

DTC No.	DTC Detection Condition	Trouble Area
C2171/71	Transmitter ID code is not registered. (When an ID code is unregistered for 3 minutes or more)	Tire pressure warning ECU

CAUTION / NOTICE / HINT

NOTICE:

When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
It is necessary to perform registration (See page ) of the transmitter IDs into the tire
pressure warning ECU if the ECU has been replaced.

PROCEDURE

1.	CONFIRM REGISTRATION CONDITION (REGISTERED ID CODES)

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(d) Turn the Techstream on.

(e) Enter the following menus: Chassis / Tire Pressure Monitor / Data List.

(f) Check the values by referring to the table below.

Tire Pressure Monitor

Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
Registered ID1 code	Registered ID1 code/ min.: 0 max.: FFFFFFF*	The ID No. registered in the transmitter ID1 is displayed	*: Displayed when the ID No. is not registered.
Registered ID2 code	Registered ID2 code/ min.: 0 max.: FFFFFFF*	The ID No. registered in the transmitter ID2 is displayed	*: Displayed when the ID No. is not registered.
Registered ID3 code	Registered ID3 code/ min.: 0 max.: FFFFFFF*	The ID No. registered in the transmitter ID3 is displayed	*: Displayed when the ID No. is not registered.
Registered ID4 code	Registered ID4 code/ min.: 0 max.: FFFFFFF*	The ID No. registered in the transmitter ID4 is displayed	*: Displayed when the ID No. is not registered.

OK:

The registered transmitter ID codes are displayed on the Techstream.

REPLACE TIRE PRESSURE WARNING ECU

2.	PERFORM REGISTRATION (TRANSMITTER ID)

(a) Register the transmitter IDs for 4 tires (See page ).

3.	READ VALUE USING TECHSTREAM (DATA LIST)

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(d) Turn the Techstream on.

(e) Enter the following menus: Chassis / Tire Pressure Monitor / Data List.

(f) Check the values by referring to the table below.

Tire Pressure Monitor

Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
ID1 Tire Inflation Pressure	ID1 tire inflation pressure/ min.: Absolute pressure/ 0 kPa (0 kgf/cm2, 0 psi), Relative pressure/ -100 kPa (-1.0 kgf/cm2, -14 psi) max.: Absolute pressure/ 638 kPa (6.4 kgf/cm2, 93 psi), Relative pressure/ 538 kPa (5.4 kgf/cm2, 78 psi)	Actual tire inflation pressure	If 0 kPa (0 kgf/cm2, 0 psi) is displayed for absolute pressure or -100 kPa (-1.0 kgf/cm2, -14 psi) is displayed for relative pressure, data has not been received*.
ID2 Tire Inflation Pressure	ID2 tire inflation pressure/ min.: Absolute pressure/ 0 kPa (0 kgf/cm2, 0 psi), Relative pressure/ -100 kPa (-1.0 kgf/cm2, -14 psi) max.: Absolute pressure/ 638 kPa (6.4 kgf/cm2, 93 psi), Relative pressure/ 538 kPa (5.4 kgf/cm2, 78 psi)	Actual tire inflation pressure	If 0 kPa (0 kgf/cm2, 0 psi) is displayed for absolute pressure or -100 kPa (-1.0 kgf/cm2, -14 psi) is displayed for relative pressure, data has not been received*.
ID3 Tire Inflation Pressure	ID3 tire inflation pressure/ min.: Absolute pressure/ 0 kPa (0 kgf/cm2, 0 psi), Relative pressure/ -100 kPa (-1.0 kgf/cm2, -14 psi) max.: Absolute pressure/ 638 kPa (6.4 kgf/cm2, 93 psi), Relative pressure/ 538 kPa (5.4 kgf/cm2, 78 psi)	Actual tire inflation pressure	If 0 kPa (0 kgf/cm2, 0 psi) is displayed for absolute pressure or -100 kPa (-1.0 kgf/cm2, -14 psi) is displayed for relative pressure, data has not been received*.
ID4 Tire Inflation Pressure	ID4 tire inflation pressure/ min.: Absolute pressure/ 0 kPa (0 kgf/cm2, 0 psi), Relative pressure/ -100 kPa (-1.0 kgf/cm2, -14 psi) max.: Absolute pressure/ 638 kPa (6.4 kgf/cm2, 93 psi), Relative pressure/ 538 kPa (5.4 kgf/cm2, 78 psi)	Actual tire inflation pressure	If 0 kPa (0 kgf/cm2, 0 psi) is displayed for absolute pressure or -100 kPa (-1.0 kgf/cm2, -14 psi) is displayed for relative pressure, data has not been received*.

HINT:

*: It may take about 2 or 3 minutes until the values are displayed.
If no "ID Tire Inflation Pressure" data has changed, reset the tire pressure to the appropriate specified value and rotate the tire 90 to 270 degrees. Then, rapidly release the tire pressure and recheck it.

Result	Proceed to
All tire pressure readings are equal to specified values.	A
Tire pressure values are not displayed.	B

END

REPLACE TIRE PRESSURE WARNING ECU

Receiver Error (C2176/76)

DESCRIPTION The signals are transmitted to the tire pressure warning antenna and receiver on the body as radio waves and then sent to the tire pressure warning ECU. DTC No. D ...

Transmitter ID not Received in Main Mode (C2126/26)

DESCRIPTION After all IDs are registered, DTC C2126/26 is set in the tire pressure warning ECU and the tire pressure warning light blinks for 1 minute and then comes on. When the tire pressure war ...

Other materials about Toyota Venza:

Back-up Power Source Circuit
DESCRIPTION The back-up power source circuit for the A/C amplifier is shown below. Power is supplied even when the ignition switch is turned off. The power is used for diagnostic trouble code memory, etc. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE ...

A/C ECU Vehicle Information Reading/Writing Processor Malfunction (B15F5)
DESCRIPTION This DTC is stored when items controlled by the air conditioning amplifier assembly cannot be customized via the audio and visual system vehicle customization screen. HINT: The air conditioning amplifier assembly controls the air conditioning ...

Position Initialization Incomplete (B2343)
DESCRIPTION This DTC is output when the sliding roof ECU (sliding roof drive gear sub-assembly) has not been initialized. DTC Code DTC Detection Condition Trouble Area B2343 Sliding roof ECU (sli ...