Replacement
REPLACEMENT
PROCEDURE
1. REMOVE TRANSMITTER HOUSING COVER
(a) Using a precision screwdriver with its tip wrapped in protective tape, pry open the transmitter housing cover. NOTICE: Do not forcibly pry the cover. HINT: Tape the screwdriver tip before use. |
|
2. REMOVE DOOR CONTROL TRANSMITTER MODULE
(a) Using a precision screwdriver with its tip wrapped in protective tape, remove the door control transmitter module from the transmitter housing case. NOTICE: Handle each part with care as they are delicate electrical parts. HINT: Tape the screwdriver tip before use. |
|
3. REMOVE TRANSMITTER BATTERY
(a) Twist the coin in the direction of the arrow in the illustration, and remove the transmitter battery cover. |
|
(b) Remove the battery (lithium battery: CR2025). NOTICE:
|
|
4. INSTALL TRANSMITTER BATTERY
(a) Install a battery (lithium battery: CR2025) with the positive (+) side facing upward, as shown in the illustration. NOTICE:
|
|
(b) Install the cover. |
|
5. INSTALL DOOR CONTROL TRANSMITTER MODULE
(a) Install the door control transmitter module into the transmitter housing case. |
|
6. INSTALL TRANSMITTER HOUSING COVER
(a) Install the transmitter housing cover to the transmitter housing case. |
|
(b) Check that the transmitter LED illuminates when the switch is pressed.
OK:
Transmitter LED illuminates when switch is pressed.
Engine Coolant Temperature Receiver Gauge Malfunction
DESCRIPTION
In this circuit, the meter CPU receives engine coolant temperature signals from
the ECM using the CAN communication system (CAN No. 1 Bus). The meter CPU displays
engine coolant temperature that is calculated based on the data received from th ...
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY)
(a) Disconnect the main body ECU (driver side junction block assembly) connectors.
(b) Measure the resistance and voltage according to the value(s) in the table
below.
...
System Description
SYSTEM DESCRIPTION
1. ENGINE IMMOBILISER SYSTEM DESCRIPTION
The immobiliser system is a theft deterrent system that determines whether to
disable starting of the SFI system based on a comparison of the key ID code and
the vehicle pre-registered code. The ...