On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT TRANSFER OIL
(a) Remove the No. 1 transfer case plug and gasket. |
|
(b) Check that the oil level is between 0 and 5 mm (0 and 0.197 in.) from the bottom lip of the case plug hole. NOTICE:
|
|
(c) Check for oil leakage if the oil level is low.
(d) Install a new gasket onto the No. 1 transfer case plug and then tighten the plug.
Torque:
49 N·m {500 kgf·cm, 36 ft·lbf}
2. ADJUST TRANSFER OIL
(a) Remove the No. 1 transfer case plug and gasket.
(b) Add oil until the oil level is between 0 and 5 mm (0 and 0.197 in.) from the bottom lip of the case plug hole.
NOTICE:
HINT:
Oil grade:
API GL-5
Viscosity:
Above 0°F(-18°C): SAE 90
Below 0°F(-18°C): SAE 80W or 80W-90
Capacity:
0.8 liters (0.84 US qts, 0.70 lmp.qts)
(c) After waiting for approximately 5 minutes, recheck the oil level.
(d) Install a new gasket onto the No. 1 transfer case plug and then tighten the plug.
Torque:
49 N·m {500 kgf·cm, 36 ft·lbf}
Data List / Active Test
DATA LIST / ACTIVE TEST
1. DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches,
sensors, actuators and other items to be read without removing any parts. This non-intrusive
inspection can be very useful bec ...
Security Indicator Light Circuit
DESCRIPTION
Even when the theft deterrent system is in the disarmed state, the security indicator
blinks due to a signal output from the immobiliser system. The security indicator
blinks continuously due to a continuous signal received from the immobilise ...
Throttle Actuator Control Motor Current Range / Performance (P2118)
DESCRIPTION
The electronic throttle control system has a dedicated power supply circuit.
The voltage (+BM) is monitored and when it is low (below 4 V), the ECM determines
that there is a malfunction in the electronic throttle control system and cuts off
...