Toyota Venza: Transfer Case Rear Oil Seal

Toyota Venza Service Manual / Mf1a Transfer / 4wd / Awd / Transfer Case Rear Oil Seal

Components

COMPONENTS

ILLUSTRATION

Replacement

REPLACEMENT

PROCEDURE

1. REMOVE TAIL EXHAUST PIPE ASSEMBLY

2. REMOVE CENTER EXHAUST PIPE ASSEMBLY

3. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

4. REMOVE TRANSFER CASE REAR OIL SEAL

(a) Using SST, remove the transfer case rear oil seal from the transfer extension housing sub-assembly.

SST: 09308-00010

NOTICE:

Be careful not to damage the oil seal contact surface or the inside surface of the oil seal.

5. INSTALL TRANSFER CASE REAR OIL SEAL

(a) Using SST and a hammer, drive in a new transfer case rear oil seal into the transfer extension housing sub-assembly until it reaches the position shown in the illustration.

SST: 09325-20010

Drive in depth:

1.1 to 1.9 mm (0.0433 to 0.0748 in.)

NOTICE:

Do not tilt the oil seal during installation.

(b) Apply a small amount of MP grease to the lip of the oil seal.

6. TEMPORARILY TIGHTEN PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

7. FULLY TIGHTEN PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

8. INSTALL CENTER EXHAUST PIPE ASSEMBLY

9. INSTALL TAIL EXHAUST PIPE ASSEMBLY

10. INSPECT TRANSFER OIL

11. INSPECT EXHAUST GAS LEAK

Transfer Case Front Oil Seal(for Rh Side)

Components COMPONENTS ILLUSTRATION Replacement REPLACEMENT PROCEDURE 1. DRAIN TRANSFER OIL (a) Remove the transfer drain plug and gasket to drain the transfer oil. (b) Install a new gask ...

Transfer Oil

On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT TRANSFER OIL (a) Remove the No. 1 transfer case plug and gasket. ...

Other materials about Toyota Venza:

Programming HomeLink® (for U.S.A. owners)
To ensure correct programming into the HomeLink®, install a new battery in the hand-held transmitter prior to programming. Failure to install a new battery into the hand-held transmitter will affect both the range and accuracy of the HomeLink® in your ...

Transmitter Battery(w/o Smart Key System)
Replacement REPLACEMENT PROCEDURE 1. REMOVE TRANSMITTER HOUSING COVER (a) Using a precision screwdriver with its tip wrapped in protective tape, pry open the transmitter housing cover. NOTICE: Do not forcibly pry the cover. HINT: ...

Key-off Operation Function Operates even if Operating Conditions are not Satisfied
DESCRIPTION When the front doors are closed, each power window regulator motor assembly can control its power window operation for approximately 45 seconds after the ignition switch is turned from ON to off by receiving operation permission ...