Toyota Venza: Transfer Case Front Oil Seal(when Not Using The Engine Support Bridge)

Toyota Venza Service Manual / Mf1a Transfer / 4wd / Awd / Transfer Case Front Oil Seal(when Not Using The Engine Support Bridge)

Components

COMPONENTS

ILLUSTRATION

Replacement

REPLACEMENT

PROCEDURE

1. REMOVE TRANSFER ASSEMBLY

(See page ).

2. REMOVE TRANSFER CASE FRONT OIL SEAL

(a) Using SST, remove the transfer case front oil seal from the transfer case.

SST: 09308-00010

NOTICE:

Do not damage the oil seal contact surface on the case.

3. INSTALL TRANSFER CASE FRONT OIL SEAL

(a) Using SST, drive in a new transfer case front oil seal into the transfer case until it reaches the position shown in the illustration.

SST: 09608-10010

SST: 09950-70010

09951-07150

Drive in depth:

9.5 to 10.5 mm (0.374 to 0.413 in.)

NOTICE:

Do not tilt the oil seal during installation.

(b) Apply a small amount of MP grease to the lip of the oil seal.

4. INSTALL TRANSFER ASSEMBLY

(See page ).

Installation

INSTALLATION PROCEDURE 1. INSTALL TRANSFER ASSEMBLY (a) Install the transfer assembly to the automatic transaxle assembly with 2 new bolts and the 6 nuts. Torque: 69 N·m {700 ...

Transfer Case Front Oil Seal(when Using The Engine Support Bridge)

Components COMPONENTS ILLUSTRATION Replacement REPLACEMENT PROCEDURE 1. REMOVE TRANSFER ASSEMBLY See page 2. REMOVE TRANSFER CASE FRONT OIL SEAL (a) Using SST, remove the t ...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. REMOVE FRONT SEAT ASSEMBLY LH (See page ) 2. REMOVE FRONT DOOR SCUFF PLATE LH 3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH 4. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH 5. REMOVE REAR DOOR SCUFF PLATE LH 6. REMOVE REAR ...

Satellite Radio Broadcast cannot be Selected or After Selecting Broadcast, Broadcast cannot be Added into Memory
CAUTION / NOTICE / HINT NOTICE: Some satellite radio broadcasts require payment. A contract must be made between a satellite radio company and the user. If the contract expires, it will not be possible to listen to the broadcast. PROCEDURE 1 ...

Adjustment
ADJUSTMENT PROCEDURE 1. PRECAUTIONS AND WORK DESCRIPTION (a) The U660E automatic transaxle does not have an oil filler tube and oil level gauge. When adding fluid, add fluid through the refill hole on the transaxle case. The fluid level can be adjusted ...