Toyota Venza: Touch Panel Switch does not Function

Toyota Venza Service Manual / Audio / Video / Audio And Visual System / Touch Panel Switch does not Function

PROCEDURE

1.	CHECK MULTI-DISPLAY

(a) Check if there is any foreign matter caught between the display and exterior frame of the multi-display.

OK:

No foreign matter is caught between the display and exterior frame of the multi-display.

HINT:

If there is foreign matter between the display and exterior frame of the multi-display, the touch panel will remain pressed, preventing touch switch operation.

REMOVE FOREIGN MATTER

2.	CHECK TOUCH PANEL

(a) Check for foreign matter on the display.

OK:

The display is clean.

CLEAN DISPLAY AND RECHECK TOUCH PANEL

3.	CHECK TOUCH SWITCH (OPERATION CHECK)

(a) Enter the "Touch Switch Check" screen. Refer to Check Touch Switch in Operation Check (See page ).

(b) Touch the display in the area where the switch malfunction occurs.

OK:

A "+" mark appears at the touched position.

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Panel Switches do not Function

PROCEDURE 1. CHECK PANEL SWITCH (a) Check for foreign matter around the switches that might prevent operation. OK: No foreign matter is found. NG ...

Screen Flicker or Color Distortion

PROCEDURE 1. CHECK DISPLAY SETTING (a) Reset display settings (contrast, brightness) and check that the screen appears normal. OK: The display returns to normal. ...

Other materials about Toyota Venza:

Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and the LH side. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE REAR WHEEL 2. REMOVE REAR AXLE SHAFT NUT (for AWD) NOTICE: Perform th ...

Terminals Of Ecu
TERMINALS OF ECU 1. TCM HINT: Each TCM terminal standard voltage is shown in the table below. In the table, first follow the information under "Condition". Look under "Terminal No. (Symbol)" for the terminals to be inspected. The st ...

Freeze Frame Data
FREEZE FRAME DATA 1. CHECK FREEZE FRAME DATA (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Navigation System / Trouble Codes. (e) Select a DTC to ...