Toyota Venza: Tire Pressure Warning Valve

TC and CG Terminal Circuit

DESCRIPTION DTC output mode is set by connecting terminals 13 (TC) and 4 (CG) of the DLC3. The DTCs are indicated by the blinking pattern of the tire pressure warning light. WIRING DIAGRAM HINT ...

Components

COMPONENTS ILLUSTRATION ...

Other materials about Toyota Venza:

Navigation Antenna
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY HINT: Refer to the procedure up to Remove Instrument Panel Safety Pad Assembly (See page ). 2. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT ...

Driver Side Seat Belt Warning Light does not Operate
DESCRIPTION When the ignition switch is ON, the center airbag sensor assembly transmits front seat inner belt status signals to the combination meter assembly through CAN. If the driver seat belt is not fastened, the combination meter assembly blinks the ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL NO. 2 STEERING RACK BOOT (a) Apply lithium soap base glycol grease to the inside of the small opening of a new No. 2 steering rack boot. (b) Install the No. 2 ste ...