Toyota Venza: Tire Pressure Monitoring
- Tire Pressure Warning Ecu
- Tire Pressure Warning Receiver
- Tire Pressure Warning System
- Precaution
- Parts Location
- System Diagram
- How To Proceed With Troubleshooting
- System Description
- Registration
- Problem Symptoms Table
- Test Mode Procedure
- Diagnosis System
- Terminals Of Ecu
- Dtc Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Vehicle Speed or Engine Speed Signal Malfunction (C2173/73)
- Receiver Error (C2176/76)
- Transmitter ID not Registered (C2171/71)
- Transmitter ID not Received in Main Mode (C2126/26)
- Engine Speed Signal Error (Test Mode DTC) (C2194/94)
- No Signal from Transmitter ID1 (C2121/21-C2124/24,C2181/81-C2184/84)
- Abnormal Temperature Inside ID1 Tire (C2165/65-C2168/68)
- Transmitter ID1 Error (C2141/41-C2144/44)
- Vehicle Speed Signal Error (Test Mode DTC) (C2191/91)
- Transmitter ID1 Operation Stop (C2111/11-C2114/14)
- ECU Power Source Circuit
- Tire Pressure Warning Light Circuit
- TC and CG Terminal Circuit
- Tire Pressure Warning Valve
Inspection
INSPECTION
PROCEDURE
1. INSPECT TIRES
(a) Inspect the tires for wear and proper inflation pressure.
Cold Tire Inflation Pressure:
Tire Size
Front
kPa (kgf/cm2, psi)
...
Tire Pressure Warning Ecu
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Removal
REMOVAL
CAUTION / NOTICE / HINT
NOTICE:
Before removing the tire pressure warning ECU, read the registered transmitter
IDs of ...
Other materials about Toyota Venza:
Removal
REMOVAL
CAUTION / NOTICE / HINT
NOTICE:
Release the vacuum from the booster by depressing the brake pedal several times.
Then remove the brake master cylinder from the brake booster.
PROCEDURE
1. REMOVE FRONT WIPER ARM HEAD CAP
2. REMOVE FRONT WIPER AR ...
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT SEAT HEADREST ASSEMBLY
2. REMOVE FRONT SEAT REAR OUTER TRACK COVER
3. REMOVE FRONT SEAT REAR INNER TRACK COVER
4. REMOVE FRONT SEAT ASSEMBLY
5. REMOVE RECLINING POWER SEAT SWITCH KNOB
6. REMOVE SLIDE AND VER ...
Check CAN Bus Lines for Short Circuit
DESCRIPTION
There may be a short circuit in the CAN bus main wire and/or CAN branch wire
when the resistance between terminals 6 (CANH) and 14 (CANL) of the DLC3 is below
54 Ω.
Symptom
Trouble Area
Resistance betwe ...
0.1738