DESCRIPTION
If an ECM that is incompatible with the engine immobiliser system is installed, the ECM stores this DTC.
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
B279C |
When an ECM that is incompatible with engine immobiliser system is installed. |
ECM |
PROCEDURE
1. |
CHECK DTC OUTPUT |
(a) Clear the DTCs (See page ).
(b) Recheck for DTCs (See page ).
OK:
DTC B279C is not output.
Result |
Proceed to |
---|---|
OK |
A |
NG (for 2GR-FE) |
B |
NG (for 1AR-FE) |
C |
A |
USE SIMULATION METHOD TO CHECK |
B |
REPLACE ECM |
C |
REPLACE ECM |
Transfer Case Rear Oil Seal
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Replacement
REPLACEMENT
PROCEDURE
1. REMOVE TAIL EXHAUST PIPE ASSEMBLY
2. REMOVE CENTER EXHAUST PIPE ASSEMBLY
3. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
4. REMOVE TRANSFER C ...
Knock Sensor
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE INTAKE MANIFOLD
(a) Remove the intake manifold (See page ).
2. REMOVE KNOCK SENSOR
(a) Disconnect the sensor connector.
...
Disposal
DISPOSAL
CAUTION / NOTICE / HINT
CAUTION:
Before performing pre-disposal deployment of any SRS component, review and closely
follow all applicable environmental and hazardous material regulations. Pre-disposal
deployment may be considered hazardous mate ...