TEST MODE PROCEDURE
1. DESCRIPTION
HINT:
When using a chassis dynamometer, brake tester, etc. to perform a vehicle test, activate test mode to avoid a "different tire diameter installed" incorrect judgment.
Test mode does not have a AWD parameter. Test mode is activated because it will prohibit a different tire diameter judgment.
Control Status |
AWD Control Status |
---|---|
During test mode |
Different tire diameter malfunction judgement (detection that tire diameter of all wheels are not same) is not performed. |
2. ACTIVATE TEST MODE
HINT:
Activate test mode before using a chassis dynamometer, brake tester, etc. to perform a vehicle test.
(a) Check that the ignition switch is off.
(b) Use either of the following methods to change the AWD control ECU to test mode.
(1) Test mode activation through the Techstream
(2) Test mode activation by shorting the TS terminal
NOTICE:
When the ignition switch is turned from off to ON, the AWD warning light will illuminate for 4 seconds. Then it will turn off.
NOTICE:
If a part of the active torque control 4WD system has a defect, the AWD warning light will illuminate.
(c) Check if the AWD warning light has changed to the test mode display.
(d) Start the engine.
Installation
INSTALLATION
PROCEDURE
1. INSTALL AIR CONDITIONING UNIT ASSEMBLY
(a) Install the air conditioning unit assembly with the 3 nuts.
Torque:
9.8 N·m {100 kgf·cm, 87 in·lbf}
NOTICE:
Tighten the nuts in the order shown in the illustration to install the ...
Precaution
PRECAUTION
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize
the following systems after the cable is reconnected.
System Name
See Procedure
Back Door Closer System
...
Assist Map Number Un-Writing (C1581)
DESCRIPTION
The power steering ECU stores this DTC when it determines that the assist map
is not written in the ECU.
HINT:
The assist map is data written in the power steering ECU to control the degree
of assistance. The assist map is selected based on ...