DESCRIPTION
DTC output mode is set by connecting terminals TC and CG of the DLC3.
DTCs are displayed by blinking of the SRS warning light.
HINT:
WIRING DIAGRAM
PROCEDURE
1. |
CHECK WIRE HARNESS (TC OF DLC3 - TC OF ECM) |
(a) Turn the ignition switch off. |
|
(b) Disconnect the connector from the ECM.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
for 2GR-FE
Tester Connection |
Condition |
Specified Condition |
---|---|---|
D1-13 (TC) - A41-16 (TC) |
Always |
Below 1 Ω |
for 1AR-FE
Tester Connection |
Condition |
Specified Condition |
---|---|---|
D1-13 (TC) - A49-7 (TC) |
Always |
Below 1 Ω |
*1 |
Front view of wire harness connector (to DLC3) |
*2 |
Front view of wire harness connector (to ECM) |
*3 |
for 2GR-FE |
*4 |
for 1AR-FE |
NG |
REPLACE WIRE HARNESS |
|
2. |
CHECK WIRE HARNESS (CG OF DLC3 - BODY GROUND) |
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
|
NG |
REPLACE WIRE HARNESS |
|
3. |
CHECK WIRE HARNESS (TC OF DLC3 - BODY GROUND) |
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
|
OK |
REPLACE CENTER AIRBAG SENSOR ASSEMBLY |
NG |
REPLACE WIRE HARNESS OR EACH ECU |
TC and CG Terminal Circuit
DESCRIPTION
DTC output mode is set by connecting terminals 13 (TC) and 4 (CG) of the DLC3.
The DTCs are indicated by the blinking pattern of the tire pressure warning light.
WIRING DIAGRAM
HINT:
When various warning lights blink continuously, a ground ...
USB Audio System Recognition/Play Error
DESCRIPTION
When a USB device or "iPod" is connected to the USB jack of the No. 1 stereo
jack adapter assembly, it must have playable files. The device must also communicate
with and be recognized by the radio and display receiver assembly. This ...
Certification ECU Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
Certification ECU Communication Stop Mode
"Smart Access/Smart Key/Wireless Tuner" is not displayed on
"CAN Bus Check&q ...