Toyota Venza: System Diagram

Parts Location

PARTS LOCATION ILLUSTRATION ...

On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. PERFORM SPARK TEST (a) Check for DTCs (See page ). NOTICE: If any DTC is output, perform troubleshooting procedures for that DTC. (b) Remove the ignition coil ...

Other materials about Toyota Venza:

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" ...

Rear Sensor Communication Malfunction (C1AED)
DESCRIPTION This DTC is stored when there is an open or short circuit in the communication line between the rear sensors and the ECU, or when there is a malfunction in a rear sensor. DTC No. DTC Detection Condition Troubl ...

Power Mirror Surface Position is not Memorized
SYSTEM DESCRIPTION If either the M1 or M2 seat memory switch is pressed, the outer mirror control ECU assembly (driver door) detects the switch operation and sends the seat memory switch signal to the main body ECU (driver side junction block assembly) vi ...