Toyota Venza: System Diagram

Toyota Venza Service Manual / Seat Belt / Seat Belt Warning System / System Diagram

SYSTEM DIAGRAM

Communication Table

Sender	Receiver	Signal	Communication Method
Center airbag sensor assembly	Combination meter assembly	Front seat inner belt buckle switch signal (for driver side) Front seat inner belt buckle switch signal (for front passenger side) Occupant detection signal	CAN

System Description

SYSTEM DESCRIPTION 1. SEAT BELT WARNING SYSTEM DESCRIPTION If a seat belt is not fastened, this system flashes the seat belt warning light or sounds the seat belt warning buzzer as a reminder. (a ...

How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT HINT: Use these procedure to troubleshoot the seat belt warning system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO W ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR NO. 2 SPEAKER ASSEMBLY (for 13 Speakers) (a) Install the rear No. 2 speaker assembly with the 2 screws. (b) Engage the clamp. 2. INSTALL REAR SPEAKER BRACKET ...

How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT 2. CUSTOMER PR ...

Inspection
INSPECTION PROCEDURE 1. INSPECT STARTER ASSEMBLY NOTICE: These tests must be performed within 3 to 5 seconds to avoid burning out the coil. (a) Perform a pull-in test. (1) Remove the nut and disconnect the lead wire from terminal C. (2) Con ...