Toyota Venza manuals

Toyota Venza: System Description

SYSTEM DESCRIPTION

1. GENERAL

(a) To assist the driver with parking the vehicle by displaying an image of the area behind the vehicle, this system has a rear television camera assembly mounted on the back door. The system displays the image on the navigation receiver assembly*1 or radio and display receiver assembly*2.

  • *1: for Navigation System
  • *2: for Audio and Visual System

(b) The rear view monitor system consists of the following components:

(1) Rear television camera assembly

(2) Navigation receiver assembly*1

(3) Radio and display receiver assembly*2

(4) ECM

  • *1: for Navigation System
  • *2: for Audio and Visual System

2. FUNCTION OF COMPONENTS

Item

Function

Rear Television Camera Assembly

  • Mounted on the back door to transmit an image of the area behind the vehicle to the navigation receiver assembly*1 or radio and display receiver assembly*2.
  • Has a color video camera that uses a Complementary Metal Oxide Semiconductor (CMOS) and a wide-angle lens.
  • Navigation Receiver Assembly*1
  • Radio and Display Receiver Assembly*2
  • Receives video signals, which contain an image of the area behind the vehicle taken with the rear television camera assembly.
  • Performs control of the system by receiving the reverse signal from the ECM via CAN communication.

ECM

Transmits a reverse signal to the navigation receiver assembly*1 or radio and display receiver assembly*2 via CAN communication.

  • *1: for Navigation System
  • *2: for Audio and Visual System

3. OPERATION EXPLANATION

(a) The navigation receiver assembly*1 or radio and display receiver assembly*2 receives the reverse signal when the ignition switch is turned to ON and the shift lever is moved to R. After receiving the reverse signal, the navigation receiver assembly*1 or radio and display receiver assembly*2 switches to the rear view monitor system.

  • *1: for Navigation System
  • *2: for Audio and Visual System
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the rear view monitor system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROU ...

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are lis ...

Other materials about Toyota Venza:

Capacity and distribution
Cargo capacity depends on the total weight of the occupants. (Cargo capacity) = (Total load capacity) — (Total weight of occupants) Steps for Determining Correct Load Limit— (1) Locate the statement “The combined weight of occupants and cargo should ...

Sliding Roof does not Move by Operating Sliding Roof Control Switch
DESCRIPTION The sliding roof ECU (sliding roof drive gear sub-assembly) receives switch slide and tilt signals and drives its built-in motor. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system ...

Front Speed Sensor RH Circuit (C0200/31,C0205/32,C1271/71,C1272/72,C1330/35,C1331/36)
DESCRIPTION The speed sensor detects wheel speed and sends the appropriate signals to the skid control ECU. These signals are used for the ABS control system. Speed sensor rotors have 48 serrations. The hall IC type speed sensor use the frequency of outp ...

© 2016-2026 Copyright www.tovenza.com

0.1389