Toyota Venza: System Description

Toyota Venza Service Manual / Supplemental Restraint Systems / Airbag System / System Description

SYSTEM DESCRIPTION

1. GENERAL

(a) Deceleration sensors used for the airbag system are installed on various parts on the vehicle and calculate the deceleration rate of each part during a collision.

(b) Depending on the situation, the center airbag sensor assembly sends a deployment signal to airbag and pretensioner based on the information from each sensor.

2. DEPLOYMENT CONDITION

(a) FRONTAL COLLISION

(1) Frontal collision signals are produced based on the information from the center airbag sensor assembly and front airbag sensors.

HINT:

*: In case of a frontal collision, the SRS ignition signal could be output with the deceleration sensor ON signal even without a signal from the front airbag sensors.

(2) Frontal collision signals are used to deploy the airbags and pretensioners except the side airbags.

(b) SIDE COLLISION (1)

(1) The side airbags are deployed based on signals from the side airbag sensors and center airbag sensor assembly.

HINT:

The curtain shield airbags and front pretensioners are deployed at the same time.

(1) The curtain shield airbags are deployed when both of the following conditions are met:

Signals from the side airbag sensors or rear airbag sensors are received.
Signal from the center airbag sensor assembly is received.

How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT HINT: *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT ...

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are lis ...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 3. REMOVE FR ...

Intuitive parking assist
The distance from your vehicle to nearby obstacles when parallel parking or maneuvering into a garage is measured by the sensors and communicated via the multi-information display and a buzzer. Always check the surrounding area when using this system. &n ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the T ...