Toyota Venza manuals

Toyota Venza: System Description

SYSTEM DESCRIPTION

1. SEAT BELT WARNING SYSTEM DESCRIPTION

If a seat belt is not fastened, this system flashes the seat belt warning light or sounds the seat belt warning buzzer as a reminder.

(a) Driver side seat belt warning light:

When the driver side seat belt is not fastened with the ignition switch ON, the driver side seat belt warning light on the combination meter assembly blinks to inform the driver. The center airbag sensor assembly detects the driver side seat belt status and sends signals to the combination meter assembly via CAN communication.

(b) Front passenger side seat belt warning light:

When the front passenger side seat belt is not fastened with the ignition switch ON and the front passenger seat occupied, check that the front passenger side seat belt warning light on the accessory meter assembly blinks. The accessory meter assembly displays the front passenger side seat belt status and whether the front passenger side seat is occupied.

(c) Seat belt warning buzzer:

When the vehicle is driven at approximately 20 km/h (13 mph) or more while the driver or front passenger side seat belt is not fastened, the seat belt warning buzzer in the combination meter assembly sounds at an interval of 1.2 seconds for 9.6 seconds. After that, the buzzer sounds at an interval of 0.4 seconds for 20 seconds.

2. FUNCTION OF MAIN COMPONENT

Component

Function

Front seat inner belt LH (driver side buckle switch)

Informs center airbag sensor of the driver side seat belt condition (fastened or unfastened).

Front seat inner belt RH (front passenger side buckle switch)

Informs center airbag sensor of the front passenger side seat belt condition (fastened or unfastened).

Occupant classification sensor

Informs center airbag sensor of the front passenger side seat condition (occupied or unoccupied).

Driver seat belt warning light

If driver side seat belt is unfastened and the ignition switch is ON, the meter ECU flashes the seat belt warning light of the combination meter assembly as a reminder.

Front passenger seat belt warning light

When front passenger side seat is occupied and the ignition switch is ON, if the front passenger side seat belt is unfastened, the meter ECU flashes the seat belt warning light on the accessory meter assembly as a reminder.

Seat belt warning buzzer

If driver or front passenger side seat belt is unfastened and the ignition switch is ON, the meter ECU sounds the buzzer as a reminder.

Parts Location
PARTS LOCATION ILLUSTRATION ILLUSTRATION ...

System Diagram
SYSTEM DIAGRAM Communication Table Sender Receiver Signal Communication Method Center airbag sensor assembly Combination mete ...

Other materials about Toyota Venza:

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE UPPER BACK WINDOW PANEL TRIM (a) Disengage the 4 clips and 4 claws, and remove the upper back window panel trim. 2. REMOVE BACK DOOR PANEL TRIM ASSEMBLY ...

Removal
REMOVAL PROCEDURE 1. REMOVE REAR WHEELS 2. REMOVE CENTER EXHAUST PIPE ASSEMBLY (a) Remove the center exhaust pipe assembly. HINT: Refer to the instructions for Removal of the exhaust pipe (See page for 2GR-FE, for 1AR-FE). 3. REMOVE PROPELLER WITH ...

Front Passenger Side Door Entry Lock Function does not Operate
DESCRIPTION If the front passenger door entry unlock function operates normally, but its entry lock function does not, this means that the request code from the front passenger door is being output normally. In this case, a malfunction in the lock sensor ...

© 2016-2024 Copyright www.tovenza.com

0.1202