Toyota Venza: System Description

Toyota Venza Service Manual / Door / Hatch / Back Door Closer System / System Description

SYSTEM DESCRIPTION

1. BACK DOOR CLOSER SYSTEM DESCRIPTION

(a) Operating any power back door switch when the back door is fully closed inputs a request signal to the power back door ECU*1 or back door closer ECU*2. The power back door ECU*1 or back door closer ECU*2 outputs a "latch release" command to the back door lock in response to the input.

(b) The latch can be released only when the back door is unlocked.

(c) 3 switches are built into the back door lock, and the power back door ECU*1 or back door closer ECU*2 monitors each switch status. The power back door ECU*1 or back door closer ECU*2 controls latch "release/ close" operations in response to the inputs from each switch.

Switch	Function
Back door courtesy switch	Detects whether back door is open or closed. This switch turns on when back door is open or ajar and turns off when it is fully closed.
Latch switch	Detects fully closed position of latch. This switch turns on when latch is in over-latch position.
Sector switch	Detects ajar position of latch. This switch turns on when latch is in open-latch position.

*1: w/ Power Back Door System
*2: w/o Power Back Door System

System Diagram

SYSTEM DIAGRAM Communication Method Transmitting ECU Receiver Signal Communication Method Main body ECU (Driver Side Junction Block Asse ...

How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT HINT: The back door closer system troubleshooting procedure is based on the premise that the power back door system is operating normally. Check the power bac ...

Other materials about Toyota Venza:

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. CHECK STEERING EFFORT (TORQUE) NOTICE: Some of these service operations may affect the SRS airbags. Read the precautionary notices concerning the SRS airbag system before servicing. (a) Stop the vehicle on a level, pav ...

Front Occupant Classification Sensor RH Collision Detection (B1786)
DESCRIPTION DTC B1786 is output when the occupant classification ECU receives a collision detection signal sent by the front occupant classification sensor RH if an accident occurs. DTC B1786 is also output when the front seat assembly RH is subjected to ...

Power Mirrors do not Return to Memorized Position
SYSTEM DESCRIPTION If either the M1 or M2 seat memory switch is pressed, the outer mirror control ECU assembly (driver door) detects the seat memory switch status and sends the switch signal to the main body ECU (driver side junction block assembly) via C ...