Toyota Venza: System Description

Toyota Venza Service Manual / Networking / Lin Communication System / System Description

SYSTEM DESCRIPTION

1. LIN COMMUNICATION SYSTEM DESCRIPTION

The LIN communication system is used for communication between the components in the table below. If communication cannot be performed through LIN communication because of an open in the communication lines or other reason, the master control ECU of the relevant system will store a DTC. Refer to the table below about the communication bus lines and connected components.

HINT:

Each component has a fail-safe function which activates to maintain the minimum performance of the system and protect the system.

Door Bus Lines

Component	Master Control	LIN Communication DTC Output Function
Main Body ECU (Driver Side Junction Block Assembly)	○	○
Power Window Regulator Motor Assembly (for Driver Side)	-	-
Power Window Regulator Motor Assembly (for Front Passenger Side)	-	-
Power Window Regulator Motor Assembly (for Rear LH Side)	-	-
Power Window Regulator Motor Assembly (for Rear RH Side)	-	-
Multiplex Network Master Switch Assembly	-	-
Sliding Roof ECU (Sliding Roof Drive Gear Assembly)*	-	-

*: w/ Sliding Roof

Certification Bus Lines

Component	Master Control	LIN Communication DTC Output Function
Certification ECU (Smart Key ECU Assembly)	○	○
Power Source Control ECU (Power Management Control Computer Assembly)	-	○
Steering Lock ECU (Steering Lock Actuator Assembly)	-	-

Air Conditioning Bus Lines

Component	Master Control	LIN Communication DTC Output Function
Air Conditioning Amplifier Assembly	○	-
Air Conditioning Control Assembly	-	-

Lighting Bus Lines

Component	Master Control	LIN Communication DTC Output Function
AFS ECU (Headlight Swivel ECU Assembly)	○	-
Inner Rear View Mirror Assembly	-	-

Parts Location

PARTS LOCATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

System Diagram

SYSTEM DIAGRAM 1. DOOR BUS LINES 2. CERTIFICATION BUS LINES [w/ Smart Key System] 3. AIR CONDITIONING BUS LINES 4. LIGHTING BUS LINES [w/ Smart Beam] ...

Other materials about Toyota Venza:

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY (a) Apply a total of 0.1 to 0.3g (0.00 ...

Front Lower Suspension Arm(when Using The Engine Support Bridge)
Components COMPONENTS ILLUSTRATION Removal REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the LH side and RH side. The following procedure is for the LH side. PROCEDURE 1. REMOVE FRONT FRAME ASSEMBLY for 1AR- ...

Open in CAN Main Bus Line
DESCRIPTION There may be an open circuit in the CAN bus main wire and/or the DLC3 branch wire when the resistance between terminals 6 (CANH) and 14 (CANL) of the DLC3 is 70 Ω or higher. Symptom Trouble Area Resista ...