DESCRIPTION
The AFS ECU (headlight swivel ECU assembly) receives signals indicating the swerve-angle from the steering angle sensor using CAN communication.
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
B2414 |
Malfunction in steering angle sensor |
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this symptom.
PROCEDURE
1. |
CHECK FOR DTC |
(a) Clear the DTCs (See page ).
(b) Check for DTCs (See page ).
OK:
DTC B2414 is not output.
OK |
USE SIMULATION METHOD TO CHECK |
|
2. |
REPLACE STEERING ANGLE SENSOR |
(a) Temporarily replace the steering angle sensor with a new or normally functioning one (See page ).
|
3. |
CHECK FOR DTC |
(a) Clear the DTCs (See page ).
(b) Check for DTCs (See page ).
OK:
DTC B2414 is not output.
OK |
END |
NG |
REPLACE AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) |
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedures to troubleshoot the power back door system.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
...
Touch Panel Switch does not Function
PROCEDURE
1.
CHECK MULTI-DISPLAY
(a) Check if there is any foreign matter caught between the display and exterior
frame of the multi-display.
OK:
No foreign matter is caught between the display and exterior frame of the m ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL THERMOSTAT
(a) Install a new gasket to the thermostat.
(b) Install the thermostat with the jiggle valve facing upward.
HINT:
The jiggle valve may be set to within 10° on either side of the prescribed
...