Toyota Venza: Steering Pad

Installation

INSTALLATION PROCEDURE 1. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY NOTICE: Do not replace the spiral cable with the battery connected and the ignition switch on (IG). Do not r ...

Components

COMPONENTS ILLUSTRATION ...

Other materials about Toyota Venza:

Inspection
INSPECTION CAUTION / NOTICE / HINT NOTICE: Ensure that fingers or articles of clothing do not get caught in moving parts when performing this test. PROCEDURE 1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (a) Check the LO operation. (1) Conne ...

VIN not Programmed or Mismatch - ECM / PCM (P0630)
MONITOR DESCRIPTION DTC P0630 is stored when the Vehicle Identification Number (VIN) is not stored in the Engine Control Module (ECM) or the input VIN is not accurate. Input the VIN with the Techstream. DTC No. DTC Detection Conditi ...

Removal
REMOVAL PROCEDURE 1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for 2GR-FE) See page 2. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for 1AR-FE) See page 3. REMOVE TRANSFER ASSEMBLY (a) Remove the 2 bolts and 6 nuts. ...