DESCRIPTION
Detection Item |
Symptom |
Trouble Area |
---|---|---|
Steering Angle Sensor Communication Stop Mode |
|
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
HINT:
PROCEDURE
1. |
CHECK CAN BUS WIRE FOR DISCONNECTION (STEERING ANGLE SENSOR BRANCH WIRE) |
(a) Turn the ignition switch off.
(b) Disconnect the connector of the steering angle sensor. Text in Illustration
|
|
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
D35-4 (CANH) - D35-3 (CANL) |
Ignition switch off |
54 to 69 Ω |
NG |
REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (STEERING ANGLE SENSOR BRANCH WIRE) |
|
2. |
CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL) |
(a) Turn the ignition switch to ON.
(b) Measure the voltage according to the value(s) in the table below. Standard Voltage:
|
|
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT) |
|
3. |
CHECK HARNESS AND CONNECTOR (GROUND TERMINAL) |
(a) Turn the ignition switch off.
(b) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
|
OK |
REPLACE STEERING ANGLE SENSOR |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR (GROUND CIRCUIT) |
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE MAGNETIC CLUTCH ASSEMBLY
(a) Place the compressor and magnetic clutch in a vise.
(b) Using SST, hold the magnetic clutch hub.
SST: 09985-00270
(c) Remove the bolt, ...
Body
General Maintenance
GENERAL MAINTENANCE
PROCEDURE
1. TIGHTEN BOLTS AND NUTS ON CHASSIS AND BODY
(a) If necessary, tighten the bolts and nuts on the chassis parts listed below.
Front axle and suspension
Drivetrain
Rear axle and suspension ...
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS system (See page
).
NOTICE:
When disconnecting the cable, s ...