Toyota Venza: Slip Indicator Light Remains ON

Toyota Venza Service Manual / Brake Control / Dynamic Control Systems / Vehicle Stability Control System / Slip Indicator Light Remains ON

DESCRIPTION

The skid control ECU is connected to the combination meter via CAN communication.

The slip indicator light blinks during VSC and/or TRAC operation.

When the system fails, the slip indicator light comes on to warn the driver (See page ).

WIRING DIAGRAM

PROCEDURE

1.	CHECK CAN COMMUNICATION SYSTEM

(a) Check if a CAN communication system DTC is output (See page ).

Result	Proceed to
DTC is not output	A
DTC is output	B

INSPECT CAN COMMUNICATION SYSTEM

2.	CHECK IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED

(a) Check if the skid control ECU connector is securely connected.

OK:

The connector is securely connected.

CONNECT CONNECTOR TO ECU CORRECTLY

3.	CHECK BATTERY

(a) Check the battery voltage.

Standard voltage:

11 to 14 V

Result	Proceed to
OK	A
NG (for 2GR-FE)	B
NG (for 1AR-FE)	C

CHECK OR REPLACE CHARGING SYSTEM OR BATTERY (for 2GR-FE)

CHECK OR REPLACE CHARGING SYSTEM OR BATTERY (for 1AR-FE)

4.	INSPECT COMBINATION METER ASSEMBLY

(a) Turn the ignition switch to ON and check the slip indicator light will come on for approximately 3 seconds (initial check).

(b) Perform the Active Test of the combination meter (meter CPU) using the Techstream (See page ).

Result	Proceed to
OK	A
NG (Initial check is normal, and the slip indicator light does not turn on or off in accordance with the Techstream operation)	B
NG (Initial check is abnormal)	C

HINT:

If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (See page ).

REPLACE BRAKE ACTUATOR ASSEMBLY

REPLACE COMBINATION METER ASSEMBLY

REPLACE ACCESSORY METER ASSEMBLY

Slip Indicator Light does not Come ON

DESCRIPTION The skid control ECU is connected to the combination meter via CAN communication. WIRING DIAGRAM Refer to Slip Indicator Light Remains ON (See page ). PROCEDURE 1. ...

TC and CG Terminal Circuit

DESCRIPTION Connecting terminals TC and CG of the DLC3 causes the ECU to display the DTC by blinking the ABS warning and slip indicator lights. WIRING DIAGRAM CAUTION / NOTICE / HINT HINT: Wh ...

Other materials about Toyota Venza:

Radio Receiver Power Source Circuit
DESCRIPTION This is the power source circuit to operate the radio and display receiver assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before performing the following inspection procedure. ...

Transfer Case Front Oil Seal(when Using The Engine Support Bridge)
Components COMPONENTS ILLUSTRATION Replacement REPLACEMENT PROCEDURE 1. REMOVE TRANSFER ASSEMBLY See page 2. REMOVE TRANSFER CASE FRONT OIL SEAL (a) Using SST, remove the transfer case front oil seal from the transfer case. S ...

Dtc Check / Clear
DTC CHECK / CLEAR HINT: Use the Techstream to read and clear the DTC of the occupant classification ECU, otherwise the DTCs cannot be read and cleared. 1. DTC CHECK (a) Turn the ignition switch off. (b) Connect the Techstream to the DLC3. (c) Turn the ...