Toyota Venza: Skid Control ECU Malfunction (C1300/62)
DESCRIPTION
The skid control ECU outputs this DTC, if malfunctions are found in the circuit inside the ECU by self diagnosis.
|
DTC Code |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
C1300/62 |
Internal failure of the skid control ECU control unit. |
Brake actuator assembly (Skid control ECU) |
PROCEDURE
|
1. |
REPLACE BRAKE ACTUATOR ASSEMBLY |
(a) Replace the brake actuator assembly (skid control ECU) (See page
.gif)
).
HINT:
This DTC is output when the skid control ECU detects a malfunction in the internal circuit.
| NEXT | .gif) |
END |
Stop Light Control Relay Malfunction (C1380/64)
DESCRIPTION
Upon receiving the hill-start assist control operating signal from the skid control
ECU, the relay contact turns on and the stop light comes on.
DTC Code
DTC Dete ...
Brake Pedal Load Sensing Switch (C1267/67)
DESCRIPTION
The brake pedal load sensing switch is turned on when the brake pedal is depressed
with force exceeding a predetermined level.
The skid control ECU detects if the brake pedal is depres ...
Other materials about Toyota Venza:
Installation
INSTALLATION
PROCEDURE
1. INSTALL LUMBAR SUPPORT ADJUSTER ASSEMBLY
(a) Install the bush.
(b) Install the lumbar support adjuster assembly with the guide and 2
screws.
...
Precaution
PRECAUTION
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize
the following systems after the cable is reconnected.
System Name
See Procedure
Back Door Closer System
...
ECU Power Source Circuit
DESCRIPTION
This is the power source for the tire pressure warning ECU.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
When replacing the tire pressure warning ECU, read the transmitter IDs
stored in the old ECU using the Techstream and writ ...
0.1843