Toyota Venza: Side doors

Toyota Venza Owners Manual / Before driving / Opening, closing and locking the doors / Side doors

The vehicle can be locked and unlocked using the entry function, wireless remote control, key or door lock switch.

- Entry function (vehicles with smart key system)

- Wireless remote control

- Key

► Vehicles with smart key system The doors can also be locked and unlocked with the mechanical key.

► Vehicles without smart key system

1. Locks all doors
2. Unlocks all doors

Turning the key unlocks the driver’s door. Turning the key again within 3 seconds unlocks the other doors.

- Door lock switch

1. Locks all doors
2. Unlocks all doors

- Inside lock button

1. Locks the door
2. Unlocks the door

The front doors can be opened by pulling the inside handles even if the lock buttons are in the lock position.

Antenna location and effective range

- Antenna location 1. Antennas outside cabin 2. Antennas inside cabin 3. Antenna outside luggage compartment - Effective range (areas within which the electronic key is detected) ...

Locking the driver’s doors from the outside without a key

Move the inside lock button to the lock position. Close the door. ►Vehicles with smart key system The door cannot be locked if the “ENGINE START STOP” switch is in ACCESSORY or IGNITI ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY NOTICE: Do not replace the spiral cable with the battery connected and the ignition switch on (IG). Do not rotate the spiral cable with the battery connected and the ig ...

Installation
INSTALLATION PROCEDURE 1. INSTALL THERMOSTAT (a) Install a new gasket to the thermostat. (b) Install the thermostat with the jiggle valve facing upward. HINT: The jiggle valve may be set to within 10° on either side of the prescribed ...

Cellular Phone Registration Failure
PROCEDURE 1. CHECK USAGE CONDITION (a) Check that the vehicle and cellular phone meet the following conditions: NOTICE: If changing cellular phone settings, updating software, etc. is necessary, make sure to obtain the per ...