DESCRIPTION
These DTCs are stored when a malfunction occurs in the navigation antenna assembly.
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
B15C0 |
Navigation antenna malfunction |
|
B15C1 |
Navigation antenna power source malfunction |
CAUTION / NOTICE / HINT
NOTICE:
Check that the navigation antenna assembly cable is properly installed and does not have any sharp bends, pinching or loose connections before performing following inspection procedure (See page ).
PROCEDURE
1. |
CHECK DTC |
(a) Clear the DTCs (See page ).
(b) Recheck for DTCs and check that no DTCs are output.
OK:
No DTCs are output.
OK |
USE SIMULATION METHOD TO CHECK |
|
2. |
INSPECT NAVIGATION ANTENNA ASSEMBLY |
(a) Remove the navigation antenna assembly (See page ). |
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
1 - 1a |
Always |
50 to 500 Ω |
*a |
Component without harness connected (Navigation Antenna Assembly) |
OK |
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
NG |
REPLACE NAVIGATION ANTENNA ASSEMBLY |
Door Courtesy Switch Circuit
DESCRIPTION
The main body ECU (driver side junction block assembly) detects the condition
of the door courtesy light switch.
WIRING DIAGRAM
PROCEDURE
1.
READ VALUE USING TECHSTREAM
(a) Connect the Techstream to the DLC3 ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL TRANSFER ASSEMBLY
(a) Install the transfer assembly to the transaxle assembly with 2 new
bolts and the 6 nuts.
Torque:
69 N·m {700 kgf·cm, 51 ft·lbf}
NOTICE:
Install the transfer ...
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT SEAT ASSEMBLY LH
(See page )
2. REMOVE FRONT DOOR SCUFF PLATE LH
3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
4. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
5. REMOVE REAR DOOR SCUFF PLATE LH
6. REMOVE REAR ...