Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
2. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL
3. REMOVE COURTESY LIGHT ASSEMBLY
4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
5. REMOVE SEAT MEMORY SWITCH
(a) Disengage the 4 claws and remove the seat memory switch from the front door trim board sub-assembly LH. |
|
Inspection
INSPECTION
PROCEDURE
1. INSPECT SEAT MEMORY SWITCH
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the seat memory switch. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL SEAT MEMORY SWITCH
(a) Engage the 4 claws to install the seat memory switch to the front door trim board sub-assembly LH.
2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
3. INSTALL COURTESY LIGHT ASSEMBLY
4. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL
5. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
Installation
INSTALLATION
PROCEDURE
1. INSTALL TRANSFER ASSEMBLY
(a) Install the transfer assembly to the transaxle assembly with 2 new
bolts and the 6 nuts.
Torque:
69 N·m {700 kgf·cm, 51 ft·lbf}
NOTICE:
Install the transfer ...
Parking Brake Switch Circuit
DESCRIPTION
This circuit is from the parking brake switch assembly to the radio and display
receiver assembly.
WIRING DIAGRAM
PROCEDURE
1.
CHECK BRAKE WARNING LIGHT
(a) Check that the brake warning light comes on when t ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL POWER STEERING ECU ASSEMBLY
(a) Engage the 4 wire harness clamps to the power steering ECU assembly.
(b) Install the power steering ECU assembly with the ...