Precaution
PRECAUTION
1. NOTICE FOR INITIALIZATION
HINT:
When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.
System Name |
See procedure |
---|---|
Back Door Closer System |
|
Power Back Door System |
2. IGNITION SWITCH EXPRESSIONS
HINT:
The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
Expression |
Ignition Switch (position) |
Engine Switch (condition) |
---|---|---|
Ignition Switch off |
LOCK |
Off |
Ignition Switch ON |
ON |
On (IG) |
Ignition Switch ACC |
ACC |
On (ACC) |
Engine Start |
START |
Start |
Parts Location
PARTS LOCATION
ILLUSTRATION
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
Seat Heater System
Symptom |
Suspected Area |
See page |
---|---|---|
Drivers seat heater does not warm up |
SEAT HTR fuse |
- |
Seat heater switch LH |
|
|
Front seat cushion heater (for power seat) |
|
|
Front seatback heater (for power seat) |
|
|
Seat heater controller |
- |
|
Wire harness or connector |
- |
|
Passengers seat heater does not warm up |
SEAT HTR fuse |
- |
Seat heater switch RH |
|
|
Front seat cushion heater (for power seat) |
|
|
Front seatback heater (for power seat) |
|
|
Seat heater controller |
- |
|
Wire harness or connector |
- |
System Diagram
SYSTEM DIAGRAM
Short in Side Squib RH Circuit (B1820/55-B1823/55)
DESCRIPTION
The side squib RH circuit consists of the center airbag sensor assembly and front
seat side airbag assembly RH.
The center airbag sensor assembly uses this circuit to deploy the airbag when
deployment conditions are met.
These DTCs are store ...
Does not Play even after Bluetooth Audio Mode is Selected
CAUTION / NOTICE / HINT
HINT:
Even if the portable player can play audio content, it may not be able to play
via the in-vehicle device. This does not necessarily indicate a malfunction of the
in-vehicle device.
PROCEDURE
1.
CHECK ...
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL NO. 1 REAR BUMPER REINFORCEMENT
(a) Install the No. 1 rear bumper reinforcement with the 6 nuts.
Torque:
68 N·m {693 kgf·cm, 50 ft·lbf}
2. INSTALL REAR BUMP ...