Toyota Venza: Screen Flicker or Color Distortion

Toyota Venza Service Manual / Audio / Video / Audio And Visual System / Screen Flicker or Color Distortion

PROCEDURE

1.	CHECK DISPLAY SETTING

(a) Reset display settings (contrast, brightness) and check that the screen appears normal.

OK:

The display returns to normal.

END

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Touch Panel Switch does not Function

PROCEDURE 1. CHECK MULTI-DISPLAY (a) Check if there is any foreign matter caught between the display and exterior frame of the multi-display. OK: No foreign matt ...

Poor Sound Quality in All Modes (Low Volume)

PROCEDURE 1. CHECK AUDIO SETTINGS (a) Set treble, middle and bass to the initial values and check that the sound is normal. OK: The sound returns to normal. HIN ...

Other materials about Toyota Venza:

Abnormal Temperature Inside ID1 Tire (C2165/65-C2168/68)
DESCRIPTION Each tire pressure warning valve and transmitter measures the tire internal temperature as well as tire pressure, and transmits the information to the tire pressure warning ECU along with the transmitter ID. If the measured temperature is out ...

Oxygen (A/F) Sensor Heater Control Circuit Low (Bank 1 Sensor 1) (P0031,P0032,P101D)
DESCRIPTION Refer to DTC P2195 (See page ). HINT: When any of these DTCs is stored, the ECM enters fail-safe mode. The ECM turns off the air fuel ratio sensor heater in fail-safe mode. Fail-safe mode continues until the ignition switch is t ...

System Description
SYSTEM DESCRIPTION 1. ENGINE IMMOBILISER SYSTEM DESCRIPTION The immobiliser system is a theft deterrent system that determines whether to disable starting of the SFI system based on a comparison of the key ID code and the vehicle pre-registered code. The ...