Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE SPOT LIGHT ASSEMBLY
(a) Using a screwdriver with its tip wrapped with protective tape, disengage the 8 claws to remove the 2 spot light lenses. Text in Illustration
|
|
(b) Using a screwdriver with its tip wrapped with protective tape and moulding remover, disengage the 2 claws (A). Text in Illustration
|
|
(c) Disengage the 4 claws (B) and disconnect the spot light housing.
(d) Using a screwdriver, disengage the 8 claws and clamp to remove the spot light housing from the 2 map light sub-assemblies. Text in Illustration
|
|
2. REMOVE SPOT LIGHT BULB
(a) Remove the 2 spot light bulbs from the 2 map light sub-assemblies.
Installation
INSTALLATION
PROCEDURE
1. INSTALL SPOT LIGHT BULB
(a) Install the 2 spot light bulbs to the 2 map light sub-assemblies.
2. INSTALL SPOT LIGHT ASSEMBLY
(a) Engage the 8 claws and clamp to connect the spot light housing to the 2 map light sub-assemblies as shown in the illustration. Text in Illustration
|
|
(b) Engage the 6 claws to install the spot light housing. Text in Illustration
|
|
(c) Engage the 8 claws to install the 2 spot light lenses. Text in Illustration
|
|
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT COMPRESSOR FOR METALLIC SOUND
(a) Check if there is abnormal metallic sound from the A/C compressor (compressor
with pulley) when the A/C switch is on and the A/C compressor (compressor with pulley)
operates.
...
Installation
INSTALLATION
PROCEDURE
1. INSTALL POWER STEERING ECU ASSEMBLY
(a) Engage the 4 wire harness clamps to the power steering ECU assembly.
(b) Install the power steering ECU assembly with the ...
Cruise Control Main Switch
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE STEERING PAD
(See page )
2. REMOVE CRUISE CONTROL MAIN SWITCH
(a) Remove the 2 screws.
(b) Disconnect t ...