REPLACEMENT
CAUTION / NOTICE / HINT
NOTICE:
HINT:
If any work is performed on the brake system or if air in the brake lines is suspected, bleed the brake system.
PROCEDURE
1. FILL RESERVOIR WITH BRAKE FLUID
(a) Remove the brake master cylinder reservoir filler cap. |
|
(b) Fill the reservoir with brake fluid.
Brake Fluid:
SAE J1703 or FMVSS No. 116 DOT 3
NOTICE:
2. BLEED BRAKE LINE
NOTICE:
Bleed the brake line of the wheel farthest from the master cylinder first.
(a) Connect a vinyl tube to the bleeder plug.
(b) Depress the brake pedal several times, and while holding down the brake pedal, loosen the bleeder plug*1.
(c) When fluid stops coming out, tighten the bleeder plug and release the brake pedal*2.
(d) Repeat steps *1 and *2 until all the air in the brake fluid is completely bled out and the new brake fluid comes out.
(e) Tighten the bleeder plug completely.
Torque:
13 N·m {133 kgf·cm, 10 ft·lbf}
(f) Repeat the above steps to replace the brake fluid of the brake lines for each wheel.
3. INSPECT FOR BRAKE FLUID LEAK
4. INSPECT FLUID LEVEL IN RESERVOIR
5. CHECK AND CLEAR DTC
(See page )
Installation
INSTALLATION
PROCEDURE
1. INSTALL AIR CONDITIONING UNIT ASSEMBLY
(a) Install the air conditioning unit assembly with the 3 nuts.
Torque:
9.8 N·m {100 kgf·cm, 87 in·lbf}
NOTICE:
Tighten the nuts in the order shown in the illustration to install the ...
Registering ID codes
The tire pressure warning valve and transmitter is equipped with a unique ID
code. When replacing a tire pressure warning valve and transmitter, it is necessary
to register the ID code of tire pressure warning valve and transmitter. Have the
ID code regi ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 3 ANTENNA CORD SUB-ASSEMBLY
(a) Pass the washer hose through the No. 3 antenna cord sub-assembly.
(b) Pass the No. 3 antenna cord sub-assembly with washer hose through
the vehicle body as shown in the il ...