REPLACEMENT
PROCEDURE
1. REPLACE RING PIN
NOTICE:
It is not necessary to remove the ring pin unless it is being replaced.
(a) Remove the 12 ring pins.
(b) Using a plastic-faced hammer, install 12 new ring pins.
Standard Protrusion Height:
Item |
Specified Condition |
---|---|
A |
5.0 to 7.0 mm (0.197 to 0.276 in.) |
B |
4.0 to 7.0 mm (0.157 to 0.276 in.) |
2. REPLACE STRAIGHT PIN
NOTICE:
It is not necessary to remove the straight pin unless it is being replaced.
(a) Remove the 14 straight pins.
(b) Using a plastic-faced hammer, install 14 new straight pins.
Standard Protrusion Height:
Item |
Specified Condition |
---|---|
A |
11.0 to 13.0 mm (0.433 to 0.512 in.) |
B |
5.0 to 7.0 mm (0.197 to 0.276 in.) |
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY)
(a) Disconnect the 2A and 2F main body ECU (driver side junction block assembly)
connectors.
(b) Measure the voltage and resistance according to the value(s) in the table
be ...
Back door
The back door can be opened using the back door opener. The back door can
be locked and unlocked using the entry function (vehicles with smart key system),
wireless remote control or door lock switch.
In addition, the power back door (if equipped) can be ...
Diagnosis System
DIAGNOSIS SYSTEM
1. DESCRIPTION
The main body ECU (driver side junction block assembly) and certification ECU
(smart key ECU assembly) control the LIN communication system. LIN communication
system data and Diagnostic Trouble Codes (DTCs) can be read thr ...