Toyota Venza: Repair

Toyota Venza Service Manual / 1ar-fe Engine Mechanical / Cylinder Head / Repair

REPAIR

PROCEDURE

1. REPAIR INTAKE VALVE SEAT

NOTICE:

Repair the seat while checking the seating position.
Keep the lip free of foreign matter.
Take off the cutter gradually to make the intake valve seat smooth.

(a) Using a 45° cutter, resurface the valve seat so that the valve seat width is more than the specification.

(b) Using 30° and 60° cutters, correct the valve seat so that the valve contacts the entire circumference of the seat. The contact should be in the center of the valve seat, and the valve seat width should be maintained within the specified range around the entire circumference of the seat.

Standard width:

1.0 to 1.4 mm (0.0394 to 0.0551 in.)

(d) Check the valve seating position.

2. REPAIR EXHAUST VALVE SEAT

NOTICE:

Repair the seat while checking the seating position.
Keep the lip free of foreign matter.
Take off the cutter gradually to make the exhaust valve seat smooth.

(a) Using a 45° cutter, resurface the valve seat so that the valve seat width is more than the specification.

(b) Using 30° and 75° cutters, correct the valve seat so that the valve contacts the entire circumference of the seat. The contact should be in the center of the valve seat, and the valve seat width should be maintained within the specified range around the entire circumference of the seat.

Standard width:

1.2 to 1.6 mm (0.0472 to 0.0630 in.)

(d) Check the valve seating position.

Reassembly

REASSEMBLY CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repair" after replacing the cylinder head sub-assembly (See page ). PROCEDURE 1. INSTALL SPARK PLUG TUBE HINT: Wh ...

Cylinder Head Gasket

...

Other materials about Toyota Venza:

Screen Flicker or Color Distortion
PROCEDURE 1. CHECK DISPLAY SETTING (a) Reset display settings (contrast, brightness) and check that the screen appears normal. OK: The display returns to normal. OK END NG ...

Identification Information
Vehicle Identification And Serial Numbers VEHICLE IDENTIFICATION AND SERIAL NUMBERS 1. VEHICLE IDENTIFICATION NUMBER (a) The vehicle identification number is stamped on the vehicle body and on the certification label as shown in the illustration. A: ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL REAR BUMPER UPPER RETAINER (a) Engage the guide. (b) Install the rear bumper upper retainer with the 2 screws. 2. INSTALL REAR TURN SIGNAL LIGHT BULB (a) Install th ...