REMOVAL
PROCEDURE
1. REMOVE NO. 1 FLOOR UNDER COVER
(a) Disengage the 4 nuts and clip, and remove the No. 1 floor under cover.
Text in Illustration
Nut (attached to under cover) |
HINT:
Rotate the clip to disengage it. The 4 nuts will remain attached to the No. 1 floor under cover.
2. REMOVE CHARCOAL CANISTER ASSEMBLY
(a) Disconnect the vent line tube from the charcoal canister assembly.
Text in Illustration
*1 |
Tube Connector |
*2 |
O-ring |
*3 |
Retainer |
*4 |
Pipe (Charcoal Canister Assembly) |
Pinch |
Pull |
NOTICE:
HINT:
Do not remove the retainer.
(b) Disconnect the air line tube from the charcoal canister leak detection pump sub-assembly.
Text in Illustration
*1 |
Tube Connector |
*2 |
O-ring |
*3 |
Pipe (charcoal canister leak detection pump sub-assembly) |
Pinch |
|
Push |
NOTICE:
(1) Push the air line tube firmly toward the charcoal canister assembly side.
(2) Pinch the tube connector as shown in the illustration.
(3) Pull out the air line tube.
(c) Disconnect the purge line hose from the charcoal canister assembly. |
|
(d) Disconnect the connector from the charcoal canister leak detection pump sub-assembly.
(e) Remove the 4 nuts. |
|
(f) Separate the 2 clips from the body to remove the charcoal canister assembly.
3. REMOVE CHARCOAL CANISTER LEAK DETECTION PUMP SUB-ASSEMBLY
(a) Before removing the charcoal canister leak detection pump sub-assembly, clean the canister by blowing air into it to ensure that the canister is free of foreign matter.
NOTICE:
(b) While disengaging the 2 claws as shown in the illustration, push the charcoal canister leak detection pump sub-assembly out using a screwdriver to remove it. Text in Illustration
HINT: Tape the screwdriver tip before use. |
|
(c) Check if the canister contains foreign matter such as mud or water.
(1) Visually check that the inside of the canister is free of foreign matter. |
|
(2) Hold the canister upside down to make sure that the canister is free of foreign matter.
If the canister contains foreign matter, replace the canister.
Rear Center Seat Inner Belt Assembly
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE REAR SEAT HEADREST ASSEMBLY
2. REMOVE REAR SEAT INNER TRACK BRACKET COVER
3. REMOVE REAR SEAT OUTER TRACK BRACKET COVER
4. DISCONNECT REAR SEAT NO. 2 RECLINING CONTR ...
Meter Illumination is Always Dark
DESCRIPTION
In this circuit, the meter CPU receives auto dimmer signals from the main body
ECU (driver side junction block assembly) using the CAN communication system (CAN
No. 1 Bus). When the meter CPU receives an auto dimmer signal, it dims the meter
...
Charge Warning Light Comes ON while Driving
PROCEDURE
1.
CHECK LOCK FUNCTION OF CLUTCH PULLEY
(a) Check the lock function with the pulley installed in the vehicle.
(1) Visually check that the rotor in the generator operates with the engine started.
(b) Check the lock ...