Toyota Venza: Removal

Toyota Venza Service Manual / 1ar-fe Cooling / Radiator / Removal

REMOVAL

PROCEDURE

1. REMOVE NO. 1 ENGINE UNDER COVER

2. REMOVE NO. 2 ENGINE UNDER COVER

3. DRAIN ENGINE COOLANT

4. REMOVE COOL AIR INTAKE DUCT SEAL

5. REMOVE INLET AIR CLEANER ASSEMBLY

6. REMOVE RADIATOR GRILLE

7. REMOVE LOW PITCHED HORN ASSEMBLY

8. REMOVE HIGH PITCHED HORN ASSEMBLY

9. REMOVE HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch)

10. REMOVE HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch)

11. DISCONNECT OUTLET RESERVE TANK HOSE

(a) Disconnect the outlet reserve tank hose from the radiator.

12. DISCONNECT NO. 1 RADIATOR HOSE

(a) Disconnect the No. 1 radiator hose from the radiator.

13. REMOVE NO. 2 RADIATOR HOSE

(a) Remove the No. 2 radiator hose.

14. DISCONNECT INLET NO. 1 OIL COOLER HOSE

(a) Disconnect the inlet No. 1 oil cooler hose from the radiator.

15. DISCONNECT OUTLET NO. 1 OIL COOLER HOSE

(a) Disconnect the outlet No. 1 oil cooler hose from the radiator.

16. REMOVE UPPER RADIATOR SUPPORT

(a) Disconnect the hood lock control cable clamp and remove the 5 bolts and upper radiator support.

17. SEPARATE COOLER CONDENSER ASSEMBLY

(a) Remove the 4 bolts and separate the cooler condenser assembly.

18. REMOVE RADIATOR ASSEMBLY

(a) Disconnect the 4 wire harness clamps and 2 connectors.

(b) Remove the radiator assembly and fan assembly with motor.

NOTICE:

Do not apply any excessive force to the cooler condenser assembly or pipe when removing the radiator assembly.

(d) Release the 3 snap fits and pull up the fan assembly with motor from the radiator assembly with the 2 guides to remove the fan assembly with motor.

Text in Illustration

*1	Snap fit
*2	Guide

Installation

INSTALLATION PROCEDURE 1. INSTALL RADIATOR ASSEMBLY (a) Install the fan assembly with motor to the radiator with the 2 guides at the bottom and 3 snap fits on the top. Text in Ill ...

Relay

On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. FAN NO. 1 RELAY (a) Remove the relay from the engine room relay block. (b) Mea ...

Other materials about Toyota Venza:

Sound Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier
DESCRIPTION The navigation receiver assembly sends a sound signal to the stereo component amplifier assembly via this circuit. The sound signal that has been sent is amplified by the stereo component amplifier assembly, and then is sent to the speakers. ...

Removal
REMOVAL PROCEDURE 1. REMOVE NO. 1 FLOOR UNDER COVER (a) Disengage the 4 nuts and clip, and remove the No. 1 floor under cover. Text in Illustration Nut (attached to under cover) HINT: Rotate the clip to disengage it. The 4 ...

Sliding Roof does not Move by Operating Sliding Roof Control Switch
DESCRIPTION The sliding roof ECU (sliding roof drive gear sub-assembly) receives switch slide and tilt signals and drives its built-in motor. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system ...