REMOVAL
PROCEDURE
1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY
HINT:
See the steps from "Remove Engine Assembly with transaxle" through "Remove Automatic Transaxle Assembly" (See page ).
2. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY
3. REMOVE VALVE BODY OIL STRAINER ASSEMBLY
4. REMOVE ATF TEMPERATURE SENSOR ASSEMBLY
(a) Disconnect the ATF temperature sensor assembly connector. |
|
(b) Remove the 4 bolts, ATF temperature sensor assembly and clamp from the transmission valve body assembly.
Text in Illustration
*a |
Clamp |
*b |
ATF Temperature Sensor Assembly Connector |
(c) Remove the O-ring from the ATF temperature sensor assembly. Text in Illustration
|
|
Dtc Check / Clear
DTC CHECK / CLEAR
1. DTC CHECK/CLEAR (When Using the Techstream)
(a) Check for DTCs.
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch to ON.
(3) Turn the Techstream on.
(4) Read the DTCs following the prompts on the Techstream. Enter ...
Ambient Temperature Sensor Circuit (B1412/12)
DESCRIPTION
The ambient temperature sensor is installed in front of the condenser. It detects
the ambient temperature to control air conditioning AUTO mode. This sensor is connected
to the A/C amplifier and detects fluctuations in the ambient temperature. ...
System Diagram
SYSTEM DIAGRAM
Communication Table
Sender
Receiver
Signal
Line
Main body ECU (Driver side junction block assembly)
Power back door ECU (Power back door motor unit)
...