REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. PRECAUTION
HINT:
See page
2. DRAIN AUTOMATIC TRANSAXLE FLUID
HINT:
3. DRAIN TRANSFER OIL (for AWD)
4. REMOVE FRONT WHEELS
5. REMOVE FRONT AXLE SHAFT NUT
(a) Using SST and a hammer, release the staked part of the front axle shaft nut. SST: 09930-00010 NOTICE: Loosen the staked part of the nut completely, otherwise the threads of the drive shaft may be damaged. |
|
(b) While applying the brakes, remove the front axle shaft nut.
6. SEPARATE FRONT STABILIZER LINK ASSEMBLY
7. SEPARATE FRONT SPEED SENSOR
(a) Remove the bolt and separate the front speed sensor from the steering knuckle. |
|
(b) Remove the bolt and clamp, and separate the front speed sensor and front flexible hose. |
|
8. SEPARATE TIE ROD ASSEMBLY
9. SEPARATE FRONT LOWER SUSPENSION ARM
10. SEPARATE FRONT AXLE ASSEMBLY
11. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
(a) Using SST, remove the front drive shaft assembly LH. SST: 09520-01010 SST: 09520-24010 09520-32040 NOTICE:
|
|
12. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH (for 2WD)
(a) Remove the bearing bracket hole snap ring from the drive shaft bearing bracket. |
|
(b) Remove the bolt and front drive shaft assembly RH from the drive shaft bearing bracket.
NOTICE:
Do not damage the boot or oil seal.
13. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH (for AWD)
(a) Remove the bearing bracket hole snap ring from the drive shaft bearing bracket. |
|
(b) Remove the bolt and front drive shaft assembly RH from the drive shaft bearing bracket.
NOTICE:
Do not damage the boot or oil seal.
Removal
REMOVAL
PROCEDURE
1. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System)
2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System)
3. REMOVE NO. 2 CONSOLE BOX CARPET
(a) Remove the No. 2 console box carpet.
...
Driver Side Power Window Auto Up / Down Function does not Operate with Power
Window Master Switch
DESCRIPTION
If the manual up/down function can be performed but the auto up/down function
cannot, then the fail-safe mode may be functioning.
If the power window initialization (See page
) has not been performed, the auto up/down function
will not oper ...
Installation
INSTALLATION
PROCEDURE
1. REPAIR INSTRUCTION
2. INSTALL REAR DOOR LOWER OUTSIDE STRIPE
(a) Refer to the illustration to position the rear door lower outside stripe.
Standard Measurement
Dimension
Measurement
A
...