REMOVAL
PROCEDURE
1. DRAIN DIFFERENTIAL OIL
(a) Using a 10 mm hexagon wrench, remove the rear differential carrier cover plug and gasket. |
|
(b) Using a 10 mm hexagon wrench, remove the rear differential drain plug and gasket to drain the differential oil. |
|
2. REMOVE REAR WHEELS
3. REMOVE CENTER EXHAUST PIPE ASSEMBLY
(a) Remove the center exhaust pipe assembly.
HINT:
Refer to the instructions for Removal of the exhaust pipe (See page
for 2GR-FE,
for 1AR-FE).
4. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
5. SEPARATE REAR SPEED SENSOR LH
6. SEPARATE REAR SPEED SENSOR RH
7. REMOVE REAR AXLE SHAFT NUT LH
8. REMOVE REAR AXLE SHAFT NUT RH
9. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY
10. SEPARATE NO. 2 PARKING BRAKE CABLE ASSEMBLY
11. REMOVE NO. 1 FLOOR UNDER COVER
12. REMOVE REAR STRUT ROD ASSEMBLY LH
13. REMOVE REAR STRUT ROD ASSEMBLY RH
14. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (w/ HID Headlight System)
15. REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY LH
16. REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY RH
17. SEPARATE REAR NO. 1 SUSPENSION ARM ASSEMBLY LH
18. SEPARATE REAR NO. 1 SUSPENSION ARM ASSEMBLY RH
19. REMOVE REAR DRIVE SHAFT ASSEMBLY LH
20. REMOVE REAR DRIVE SHAFT SNAP RING LH
21. REMOVE REAR DRIVE SHAFT ASSEMBLY RH
22. REMOVE REAR DRIVE SHAFT SNAP RING RH
23. SEPARATE NO. 3 FLOOR WIRE (w/ HID Headlight System)
24. SEPARATE FRAME WIRE
25. REMOVE REAR SUSPENSION MEMBER
26. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY WITH DIFFERENTIAL SUPPORT
(a) Remove the 2 bolts and 2 nuts. HINT: The nuts have tabs to prevent them from rotating. |
|
(b) Remove the 3 rear mounting bolts and rear differential carrier assembly with differential support from the rear suspension member assembly. |
|
27. REMOVE DIFFERENTIAL SUPPORT
(a) Remove the 3 bolts and differential support. |
|
28. REMOVE REAR NO. 1 DIFFERENTIAL SUPPORT
(a) Remove the 2 bolts, 2 nuts and rear No. 1 differential support. HINT: The nuts have tabs to prevent them from rotating. |
|
29. REMOVE REAR DIFFERENTIAL DYNAMIC DAMPER
HINT:
This step should be performed only when the rear differential dynamic damper is being replaced.
(a) Remove the bolt and rear differential dynamic damper. |
|
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE POSITION INDICATOR HOUSING SUB-ASSEMBLY
(a) Remove the shift lever cap from the position indicator housing sub-assembly.
(b) Disengage the 4 claws and remove the position indicator housing sub-assembly.
...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Perform "Inspection After Repair" after replacing the camshaft, No. 2 camshaft,
camshaft timing gear assembly, camshaft timing exhaust gear assembly or cylinder
head sub-assembly (See page ).
PROCED ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)
(a) Measure the resistance according to the value(s) in the table below.
Text in Illustration
*1
Body Ground
Stan ...