REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE REAR WHEEL
2. SEPARATE REAR SPEED SENSOR
(a) Remove the bolt and separate the rear speed sensor from the rear axle carrier sub-assembly. NOTICE: Keep the sensor tip and rear speed sensor installation hole free of foreign matter. |
|
3. REMOVE REAR AXLE SHAFT NUT
4. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
5. REMOVE REAR DISC
6. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY
(a) Put matchmarks on the rear drive shaft assembly and rear axle hub and bearing assembly. Text in Illustration
NOTICE: Do not punch the matchmarks. |
|
(b) Using a plastic hammer, separate the rear drive shaft assembly from the axle hub and bearing assembly. If it is difficult to separate, tap the end of the rear drive shaft assembly using a brass bar and a hammer. |
|
(c) Remove the 4 bolts and the rear axle hub and bearing assembly. NOTICE:
|
|
Installation
INSTALLATION
PROCEDURE
1. TEMPORARILY INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY LH
(a) Temporarily install the rear No. 1 suspension arm assembly LH to
the rear suspension member with the bolt (B).
Text in Illustration
...
Installation
INSTALLATION
PROCEDURE
1. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY
NOTICE:
When install a new brake master cylinder sub-assembly, remove the protectors
from the piston and outlet ports.
(a) Install a new O-ring to the brake master cylinder sub-assembl ...
Precaution
PRECAUTION
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize
the following systems after the cable is reconnected.
System Name
See Procedure
Back Door Closer System
...