Toyota Venza: Removal

Toyota Venza Service Manual / Axle And Differential / Rear Axle Hub(for 2wd) / Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.

PROCEDURE

1. REMOVE REAR WHEEL

2. SEPARATE REAR FLEXIBLE HOSE

3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

4. REMOVE REAR DISC

5. SEPARATE REAR SPEED SENSOR WIRE

6. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY

(a) Remove the 4 bolts and the rear axle hub and bearing assembly.

NOTICE:

Use wire or an equivalent tool to keep the parking brake assembly from hanging down by the parking brake cable assembly.

On-vehicle Inspection

ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE REAR W ...

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL REAR AXLE HUB ...

Other materials about Toyota Venza:

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE GENERATOR PULLEY CAP (a) Using a screwdriver, puncture the center of the generator pulley cap and pry it off. NOTICE: Do not reuse the generator pulley cap. ...

Removal
REMOVAL PROCEDURE 1. REMOVE REAR WHEELS 2. REMOVE CENTER EXHAUST PIPE ASSEMBLY (a) Remove the center exhaust pipe assembly. HINT: Refer to the instructions for Removal of the exhaust pipe (See page for 2GR-FE, for 1AR-FE). 3. REMOVE LOWER NO. 1 EXH ...

Installation
INSTALLATION PROCEDURE 1. INSTALL CHARCOAL CANISTER LEAK DETECTION PUMP SUB-ASSEMBLY (a) Engage the 2 claws to install a new charcoal canister leak detection pump sub-assembly to the charcoal canister assembly. NOTICE: Do n ...