REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
2. REMOVE FRONT SEAT ASSEMBLY LH
HINT:
Refer to the instructions for Removal of the front seat assembly.
3. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System)
4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System)
5. REMOVE NO. 2 CONSOLE BOX CARPET
6. REMOVE CONSOLE BOX ASSEMBLY
7. REMOVE AIR CONDITIONING CONTROL ASSEMBLY
8. REMOVE FRONT DOOR SCUFF PLATE LH
9. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
10. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
11. REMOVE FRONT DOOR SCUFF PLATE RH
12. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
13. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
14. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY
15. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
16. REMOVE POSITION INDICATOR HOUSING ASSEMBLY
17. REMOVE CONSOLE BOX SUB-ASSEMBLY
18. SEPARATE PARKING BRAKE PEDAL ASSEMBLY
(a) Turn back the floor carpet.
(b) Disconnect the heated oxygen sensor connector and disengage the 2 clamps (for 2GR-FE). |
|
(c) Remove the bolt and nut, and separate the No. 1 parking brake cable assembly from the body.
(d) Disconnect the parking brake switch connector. |
|
(e) Remove the 3 nuts and separate the parking brake pedal assembly from the body. |
|
19. REMOVE PARKING BRAKE SWITCH ASSEMBLY
(a) Remove the screw and parking brake switch assembly. |
|
Sound Quality is Bad Only when CD is Played (Volume is Too Low)
PROCEDURE
1.
REPLACE CD AND RECHECK
(a) Replace the CD with a new or known good one and check that the malfunction
disappears.
OK:
Malfunction disappears.
OK
END
NG
REPLACE ...
Navigation Receiver Assembly Power Source Circuit
DESCRIPTION
This is the power source circuit to operate the navigation receiver assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following
inspection procedure.
PROCE ...
Battery
- Battery exterior
Make sure that the battery terminals are not corroded and that there are no loose
connections, cracks, or loose clamps.
1. Terminals
2. Hold-down clamp
- Before recharging
When recharging, the battery produces hydrogen g ...