REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
2. REMOVE FRONT SEAT ASSEMBLY LH (for Manual Seat)
HINT:
Refer to the procedure up to Remove Front Seat Assembly (See page ).
3. REMOVE FRONT SEAT ASSEMBLY LH (for Power Seat)
HINT:
Refer to the procedure up to Remove Front Seat Assembly (See page )
4. REMOVE FRONT SEAT ASSEMBLY RH (for Manual Seat)
HINT:
Perform the same procedure as the LH side.
5. REMOVE FRONT SEAT ASSEMBLY RH (for Power Seat)
HINT:
Perform the same procedure as the LH side.
6. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System)
7. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System)
8. REMOVE NO. 2 CONSOLE BOX CARPET
9. REMOVE CONSOLE BOX ASSEMBLY
10. REMOVE AIR CONDITIONING CONTROL ASSEMBLY
11. REMOVE FRONT DOOR SCUFF PLATE LH
12. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
13. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
14. REMOVE FRONT DOOR SCUFF PLATE RH
15. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
16. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
17. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY
18. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
19. REMOVE POSITION INDICATOR HOUSING ASSEMBLY
20. REMOVE CONSOLE BOX SUB-ASSEMBLY
21. REMOVE NO. 4 CENTER MEMBER FLOOR REINFORCE SUB-ASSEMBLY
(a) Turn back the floor carpet.
(b) Remove the 7 bolts and No. 4 center member floor reinforce sub-assembly. |
|
22. REMOVE YAW RATE AND ACCELERATION SENSOR
(a) Disconnect the connector from the yaw rate and acceleration sensor with bracket.
(b) Remove the 2 bolts and yaw rate and acceleration sensor with bracket. |
|
(c) Remove the 2 nuts and yaw rate and acceleration sensor from the bracket. |
|
Hitch
Trailer hitch assemblies have different weight capacities. Toyota recommends
the use of Toyota hitch/bracket for your vehicle. For details, contact your Toyota
dealer.
• If you wish to install a trailer hitch, contact your Toyota dealer.
• Use only a ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT DRIVER SIDE LUMBAR SWITCH
(a) Measure the resistance between the terminals when the switch is operated.
Standard Resistance:
Tester Connection
Switch Condition
...
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
The rear speed sensor is a component of the rear axle hub and bearing
assembly. If the sensor malfuncti ...