Toyota Venza: Removal

Toyota Venza Service Manual / Brake Control / Dynamic Control Systems / Steering Angle Sensor / Removal

REMOVAL

CAUTION / NOTICE / HINT

NOTICE:

Do not remove the steering angle sensor from the spiral cable.

HINT:

The steering angle sensor is a component of the spiral with sensor cable sub-assembly. If the steering angle sensor malfunctions, replace the spiral with sensor cable sub-assembly.

PROCEDURE

1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing (See page )

2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

4. REMOVE LOWER NO. 3 STEERING WHEEL COVER

5. REMOVE LOWER NO. 2 STEERING WHEEL COVER

6. REMOVE STEERING PAD

7. REMOVE STEERING WHEEL ASSEMBLY

8. REMOVE LOWER STEERING COLUMN COVER

9. REMOVE UPPER STEERING COLUMN COVER

10. REMOVE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

(a) Remove the spiral with sensor cable sub-assembly (See page ).

NOTICE:

Do not replace the spiral cable with the battery connected and the engine switch on (IG).
Do not rotate the spiral cable with the battery connected and the engine switch on (IG).
Ensure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
Do not remove the steering angle sensor from the spiral cable.
Never use the steering angle sensor detached from spiral cable.

HINT:

The steering angle sensor is a component of the spiral with sensor cable sub-assembly. If the steering angle sensor malfunctions, replace the spiral with sensor cable sub-assembly.

Installation

INSTALLATION PROCEDURE 1. INSTALL SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY (a) Install the spiral with sensor cable sub-assembly (See page ). NOTICE: Do not replace the spiral cable with t ...

Vehicle Stability Control System

...

Other materials about Toyota Venza:

Power Mirrors do not Return to Memorized Position
SYSTEM DESCRIPTION If either the M1 or M2 seat memory switch is pressed, the outer mirror control ECU assembly (driver door) detects the seat memory switch status and sends the switch signal to the main body ECU (driver side junction block assembly) via C ...

Door Courtesy Switch Circuit
DESCRIPTION When an additional transponder key is registered, the transponder key ECU assembly detects the front door courtesy light switch assembly (for driver side) open/close condition, and enters the key registration mode. WIRING DIAGRAM CAUTION / ...

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" ...