REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
2. REMOVE REAR WHEEL
3. SEPARATE REAR SPEED SENSOR WIRE
(a) Using a screwdriver, disconnect the connector from the rear speed sensor. NOTICE: Be careful not to damage the rear speed sensor. |
|
4. SEPARATE REAR FLEXIBLE HOSE
5. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
6. REMOVE REAR DISC
7. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY
(a) Remove the rear axle hub and bearing assembly (See page ).
HINT:
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON and turn the Techstream on.
(c) Enter the following menus: Body Electrical / Trouble Codes.
(d) Check for DTCs.
2. CLEAR DTC
(a) Connect the Techst ...
Relay
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT IG2 RELAY
(a) Remove the IG2 relay from the relay block.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Te ...
Front Seat Inner Belt Assembly
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT SEAT INNER BELT ASSEMBLY LH (w/ Seat Position Memory System)
(a) Measure the resistance according to the value(s) in the table below.
...