REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
2. REMOVE FRONT WHEEL
3. REMOVE FRONT FENDER OUTSIDE MOULDING LH
4. REMOVE FRONT FENDER LINER LH
5. REMOVE FRONT SPEED SENSOR
(a) Disconnect the front speed sensor connector and remove the 2 clamps. |
|
(b) Remove the bolt and No. 2 sensor clamp from the body. Text in Illustration
|
|
(c) Remove the bolt, No. 1 sensor clamp and flexible hose together from the shock absorber assembly. Text in Illustration
|
|
(d) Remove the bolt, resin clamp and front speed sensor. NOTICE:
|
|
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Driver Seat / Trouble Codes.
(e) Check for DTCs (See page ).
2. CLEA ...
Hydraulic Test
HYDRAULIC TEST
1. PERFORM HYDRAULIC TEST
(a) Measure the line pressure.
CAUTION:
The line pressure test should always be carried out with at least 2 people. One
person should observe the condition of wheels and wheel chocks while the other is
perform ...
Installation
INSTALLATION
PROCEDURE
1. REPAIR INSTRUCTION
(a) Clean the vehicle body surface.
(1) Using a heat light, heat the vehicle body surface.
Heating Temperature
Item
Temperature
Vehicle Body
40 to 60°C (104 t ...