REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
2. REMOVE RADIATOR RESERVE TANK ASSEMBLY
(a) Remove the radiator reserve tank assembly. |
|
(b) Remove the radiator reserve tank cap assembly.
3. REMOVE BRAKE ACTUATOR WITH BRACKET
(a) Remove the clamp and separate the suction hose sub-assembly from the brake actuator bracket assembly. |
|
(b) Using union nut wrenches (10 mm and 12 mm), disconnect the 6 brake lines from the brake actuator with bracket. Text in Illustration
|
|
(c) Use tags or make a memo to identify the places to reconnect. Text in Illustration
|
|
(d) Release the lock lever and disconnect the brake actuator connector. NOTICE: Be careful not to allow brake fluid to enter the removed connector. |
|
(e) Remove the nut, 2 bolts and brake actuator with bracket from the body. NOTICE: Do not damage the brake lines or wire harness. |
|
4. REMOVE BRAKE ACTUATOR ASSEMBLY
(a) Loosen the 2 nuts and remove the brake actuator assembly from the brake actuator bracket assembly. |
|
Front Wiper Rubber
Components
COMPONENTS
ILLUSTRATION
Replacement
REPLACEMENT
PROCEDURE
1. REMOVE FRONT WIPER BLADE
(a) Remove the holder of the front wiper blade.
(b) Remove the front wiper blade from the f ...
Light Sensor Circuit Malfunction (B1244)
DESCRIPTION
The automatic light control sensor detects ambient light, converts it into an
electrical signal, and outputs it to the main body ECU (driver side junction block
assembly). The main body ECU (driver side junction block assembly) turns on or off ...
Power Source Mode does not Change to ON (ACC)
DESCRIPTION
When the engine switch is pushed with the electrical key in the cabin, the power
management control ECU receives signals to change the power source mode.
HINT:
To allow use of the Techstream to inspect the push-button start function when
the ...