Toyota Venza: Removal

Toyota Venza Service Manual / Brake (front) / Front Brake / Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the LH side and RH side.
The following procedure listed is for the LH side.

PROCEDURE

1. REMOVE FRONT WHEEL

2. DRAIN BRAKE FLUID

NOTICE:

If brake fluid leaks onto any painted surface, immediately wash it off.

3. SEPARATE FRONT FLEXIBLE HOSE

(a) Remove the union bolt and gasket, and separate the front flexible hose from the front disc brake cylinder assembly.

4. REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY

(a) Remove the 2 bolts and the front disc brake cylinder assembly from the front disc brake cylinder mounting.

5. REMOVE FRONT DISC BRAKE PAD

(a) Remove the 2 anti-squeal springs from the front disc brake pads.

(b) Using a screwdriver, push the protrusion of the front disc brake pad support plate as shown in the illustration and remove the 2 front disc brake pads from the front disc brake cylinder mounting.

Text in Illustration

*1	Protrusion

NOTICE:

When remove the front disc brake pad, replace the front disc brake pad support plates with new ones.

6. REMOVE FRONT ANTI-SQUEAL SHIM

(a) Remove the 2 front anti-squeal shims from the front disc brake pads.

7. REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE

(a) Remove the 2 front disc brake pad support plates from the front disc brake cylinder mounting.

8. REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN

(a) Remove the front disc brake cylinder slide pin from the front disc brake cylinder mounting.

9. REMOVE NO. 2 FRONT DISC BRAKE CYLINDER SLIDE PIN

(a) Remove the No. 2 front disc brake cylinder slide pin from the front disc brake cylinder mounting.

10. REMOVE FRONT DISC BRAKE CYLINDER SLIDE BUSHING

(a) Using a screwdriver with its tip wrapped with protective tape, remove the front disc brake cylinder slide bushing from the No. 2 front disc brake cylinder slide pin.

Text in Illustration

*1	Protective Tape

NOTICE:

Be careful not to damage the No. 2 front disc brake cylinder slide pin.

11. REMOVE FRONT DISC BRAKE BUSHING DUST BOOT

(a) Remove the 2 front disc brake bushing dust boots from the front disc brake cylinder mounting.

12. REMOVE FRONT DISC BRAKE CYLINDER MOUNTING

(a) Remove the 2 bolts and the front disc brake cylinder mounting.

13. REMOVE FRONT DISC

(a) Put matchmarks on the front disc and front axle hub.

Text in Illustration

Matchmark

HINT:

The above step is not necessary when the front disc will be replaced.

(b) Remove the front disc.

14. REMOVE FRONT DISC BRAKE BLEEDER PLUG

(a) Remove the front disc brake bleeder plug cap.

(b) Remove the front disc brake bleeder plug.

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Inspection

INSPECTION PROCEDURE 1. INSPECT PAD LINING THICKNESS (a) Using a ruler, measure the pad lining thickness. Text in Illustration *1 Ruler ...

Other materials about Toyota Venza:

Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE: If automatic transaxle assembly parts are replaced, refer to Parts Replacement Compensation Table to determine if any additional operations are necessary (See page ). PROCEDURE 1. DISCHARGE FUEL PRESSURE See p ...

Air Conditioning Panel
Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL AIR CONDITIONING CONTROL ASSEMBLY (a) Connect the connector. (b) Engage the 2 clips and 4 guides. (c) Rem ...

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" ...